To replace the spring on a weed eater, first, ensure the tool is unplugged or the battery is removed for safety. Disassemble the weed eater by removing the spool cover and line, then locate the spring, which is usually found in the spool assembly. Remove the old spring and replace it with a new one, ensuring it is properly seated in place. Reassemble the weed eater by putting the spool cover back on and reloading the line before testing the tool.
you would take off the cover and expose the recoil spring/shaft then detach the string and put the new one on
sthilweedeaterhead number f5556
i need to replace the flex shaft in my weedeater. how do i do it?
The manual can be found at the link below.
pop the spool out wind string in direction of arrow, replace
To replace the head on a Husqvarna weedeater, first, ensure the engine is off and remove the spark plug wire for safety. Use a wrench to hold the spindle in place while unscrewing the old head by turning it counterclockwise. Align the new head with the spindle and screw it on clockwise until secure. Finally, reattach the spark plug wire and test the weedeater.
To replace the pull string on a Toro weedeater, first ensure the engine is off and cool. Remove the starter cover by unscrewing any screws, then take out the spool containing the old string. Thread a new string through the spool, wind it tightly in the direction indicated, and reassemble the spool into the housing. Finally, reattach the starter cover, and your weedeater will be ready for use.
You can replace the spring with proper tools. Be VERY CAREFUL a spring that is not caged can inflict serious injury.
Your local hardware store should be able to tell you how particularly if they sell the same machine
how to replace a clock spring in a 95 honda civic ex
To replace the line on a Stihl KM56RC Weedeater, first, turn off the engine and disconnect the spark plug for safety. Remove the cutting head by unscrewing the knob at the bottom. Take off the spool and unwind any old line, then cut a new line to the desired length (typically 10-12 feet). Thread the new line through the spool holes, wind it tightly in the direction indicated, and reassemble the cutting head before reattaching it to the Weedeater.
http://www.stihllibrary.com/pdf/trimmerheads/AUTOCUT_25-2_101001.pdf Go to this link and all the string replacement guides are there.