To remove the firing pin from a Winchester Model 100, first ensure the firearm is unloaded and safe to handle. Disassemble the rifle by removing the stock and bolt assembly. Once the bolt is accessible, locate the firing pin retaining pin or screw, remove it, and gently slide out the firing pin from the bolt assembly. Reassemble the rifle by reversing the disassembly steps.
This would be best left to a qualified gunsmith.
The Ted Williams model 100 was a Winchester model 1894 rifle.Use this model to order a new firing pin.
Your sears ted williams model 100 is actually a winchester model 1894 rifle that was made by winchester for sears.You can find a firing pin at numrich gun parts corp.They can be found on the web.
This would be best left to a qualified gunsmith.
gunpatscorp.comSears Model 300 firing pinIf the Model 300 is the lever-action .30-30 that Sears sold in the '50s it's a part-for-part copy of a Winchester '94. In fact, Winchester probably made it to be sold under the Sears name. If that's the case, a firing pin for a Winchester '94 can be made to fit it. POST '64, not pre-64The Ted Williams/Sears 100 is a post-64 Winchester 94, and requires a post-64 firing pin. We do have them available. sales@countrygunsmith.net
Nearly the last step in this tutorial is taking out the firing pin. http://www.castbullet.com/misc/tdown.htm Good luck
There was a recall related to the firing pins on the Model 100. The pin is subject to breakage and could stick in the forward position resulting in the gun slam-firing. Contact us for directions or futher information on repairing the rifle. sales@countrygunsmith.net
Any local gun shop should be able to assist you.
Take it to an authorized repair center or a qualified gun smith.
Take it to a gunsmith. Remove cylinder - remove firing pin pin located under rear site - use finishing nail/small center punch ,place against back of firing pin and tap lightly driving pin toward "removed" cylinder
To remove the firing pin from a Ruger P89, first ensure the firearm is unloaded and the magazine is removed. Disassemble the pistol by removing the slide from the frame, then take out the recoil spring and barrel. Next, locate the firing pin retaining pin at the rear of the slide, remove it, and then carefully pull out the firing pin along with the firing pin spring. Always follow safety protocols and consult the owner's manual for specific instructions.