Best left to a gunsmith
To remove the firing pin from a Ruger P89, first ensure the firearm is unloaded and the magazine is removed. Disassemble the pistol by removing the slide from the frame, then take out the recoil spring and barrel. Next, locate the firing pin retaining pin at the rear of the slide, remove it, and then carefully pull out the firing pin along with the firing pin spring. Always follow safety protocols and consult the owner's manual for specific instructions.
Firing Pin Block
A pistol by loading ammunition into the chamber. The firing the pin then strikes the cartridge, which causes the pistol to discharge.
The purpose of Beretta's firing pin catch is to prevent the firing pin from going forward from in the event that the pistol is dropped. It's just simply redundancy, every precaution to not put little holes into your body is taken.
No, but, e-gunparts.com might.
what's the question ???
If the decocker is n the fire position, and a round is chambered, the hammer will rise and fall, striking the firing pin. The pin will strike the primer of the cartridge, firing the pistol.
Take it to a gunsmith. Remove cylinder - remove firing pin pin located under rear site - use finishing nail/small center punch ,place against back of firing pin and tap lightly driving pin toward "removed" cylinder
To change the firing pin on an Accu-Tek HC380, first ensure the firearm is unloaded and the magazine is removed. Disassemble the pistol according to the manufacturer's instructions, typically by removing the slide from the frame. Locate the firing pin assembly, which is usually secured by a retaining pin or spring; remove this component carefully. Replace the old firing pin with a new one, reassemble the firearm, and ensure everything is functioning correctly before use.
To remove the firing pin from a Winchester Model 100, first ensure the firearm is unloaded and safe to handle. Disassemble the rifle by removing the stock and bolt assembly. Once the bolt is accessible, locate the firing pin retaining pin or screw, remove it, and gently slide out the firing pin from the bolt assembly. Reassemble the rifle by reversing the disassembly steps.
You need the services of a good gunsmith or machinist
That's a task best left to a gunsmith.