To open the weed eater head to replace the trimmer line, first, locate the tabs on the side of the head. Press and hold these tabs while twisting the head counterclockwise to unlock it. Once unlocked, carefully remove the head to access the spool and replace the trimmer line.
To remove the head of a Ryobi Expand-It weed eater, you typically need to unscrew the bump knob or cap on the head of the trimmer. Once the knob is removed, you can access the spool and remove it from the head. This allows you to detach the head from the weed eater for maintenance or replacement.
To restring a Ryobi Expand-It weed eater, first remove the spool from the trimmer head. Cut a length of new trimmer line, thread it through the eyelet holes on the spool, and wind it evenly in the direction indicated on the spool. Reattach the spool to the trimmer head and trim any excess line.
Nylon
To restring a Ryobi Expand-It weed eater, first remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert the line into the spool following the arrows for the correct winding direction. Secure the line in the notches on the spool and reassemble the spool onto the trimmer head.
The Weed Eater Electric Trimmer is one of the easiest to use
To properly string a weed eater, first, turn off the engine and disconnect the spark plug. Then, remove the spool from the trimmer head and unwind any remaining old string. Cut a new piece of trimmer line to the recommended length and insert it into the spool, following the directional arrows. Finally, reassemble the spool onto the trimmer head and secure it in place.
To load weed eater line on a Craftsman trimmer, first, turn off the trimmer and unplug it if it's electric. Remove the spool from the head by pressing the tabs and pulling it out. Cut a length of trimmer line (typically around 10-15 feet), then insert one end into the spool's eyelet and wind the line in the direction indicated by the arrow on the spool. Finally, replace the spool back into the trimmer head and pull the line to ensure it feeds properly.
A line trimmer, also known as a string trimmer, is used to trim grass or weeds. The piece of equipment also goes by the name of a weed eater, or weed whacker.
To properly restring a Ryobi weed eater, first remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert one end of the line into the hole in the spool and wind it in the direction indicated on the spool until it is full. Secure the line in the notches on the spool and reassemble the spool onto the trimmer head. Cut the line to the desired length and you're ready to trim.
The best type of weed eater trimmer line for cutting through tough vegetation is a heavy-duty, twisted or serrated line with a thicker diameter. These types of trimmer lines are more durable and can easily cut through dense and tough vegetation.
0.080" per 1993 manual