Remove the slide. Push firing pin forward with 1/16" pin punch & then put a 3/32" pin punch between the back end of the firing pin & the back of the slot in the slide to hold the firing pin forward. Place the end of a small straight tip screwdriver between the right side end of the safety & the interior wall of the slide. Now twist the screwdriver to move the safety out to the left side of the slide. As you do this slowly, be carefull not to let the safety plunger & spring fly away on you. Mine tends to pretty well stay in the hole & not fly out. Once you have the safety out of the slide, carefully remove the 3/32" pin punch holding the firing pin forward to allow removal of the firing pin & spring. Reverse the procedure to reinstall.
To change the firing pin on an Accu-Tek HC380, first ensure the firearm is unloaded and the magazine is removed. Disassemble the pistol according to the manufacturer's instructions, typically by removing the slide from the frame. Locate the firing pin assembly, which is usually secured by a retaining pin or spring; remove this component carefully. Replace the old firing pin with a new one, reassemble the firearm, and ensure everything is functioning correctly before use.
50-75 USD
50-75 USD
No known sn data has been published.
60 or so
You have not asked a question yet. Please reword it, and try again.
Düm Tek Tek was created in 2008.
Tek Jansen was created in 2005.
Vedat Tek died in 1942.
Vedat Tek was born in 1873.
nail tek renew
Ong Iok-tek was born in 1924.