answersLogoWhite

0

What else can I help you with?

Related Questions

What is the average time that a cordless trimmer will operate?

The average time a cordless trimmer will operate is about thirty minutes. Of course, this depends on the size of the trimmer compared to the size of its battery, or even the amount of work it has to weed through.


What is the purpose of a line trimmer?

A line trimmer, also known as a string trimmer, is used to trim grass or weeds. The piece of equipment also goes by the name of a weed eater, or weed whacker.


How do You restring a Honda weed trimmer?

You remove the bottom cover off the weed trimmer, and remove the tangled old wire. Insert the new wire into the side of the trimmer and wrap it around the black spindle.


What is the fuel ratio mixture for a Toro weed trimmer?

I purchased my Toro weedeater in 2007. It uses a 50:1 gas/oil ratio.


What is the gas oil ratio mix for a homelite st185 weed trimmer?

40:1 owner's manual for a homelite st 185 trimmer says 32:1


What is the past tense of weed-eat?

weed-ate, or cut with the string trimmer


What is weed eater trimmer line made of?

Nylon


Which brand of trimmer is the easiest to use and unspool?

The Weed Eater Electric Trimmer is one of the easiest to use


What is gas to oil ratio for 24cc trimmer?

what is the gas/oil mix for the 24cc weed trimmer by craftsman


My craftsman weed trimmer runs on the ground but shuts off when you pick it up?

I solved my own problem,my weed trimmer has a on and off switch the wire in the switch had a bare place that was shorting out, by lifting the trimmer I was putting pressure one the bad connection.


What is the difference between a weedwhacker and trimmer?

weed-whacker- for trimming ground plants/weeds trimmer- for trimming bushes or shrubbery


What is the best method for replacing the weed trimmer line on a string trimmer?

To replace the weed trimmer line on a string trimmer, follow these steps: Turn off the trimmer and disconnect the power source. Remove the spool housing by pressing the tabs or unscrewing the cap. Take out the old line and cut a new piece to the appropriate length. Insert the new line into the trimmer head following the arrows for the correct direction. Reassemble the spool housing and test the trimmer.