answersLogoWhite

0

Best left to a gunsmith

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is an extractor rod use for?

Extracting things!


What are the advantages of a shrouded extractor rod on a revolver?

The shroud around the extractor rod was developed during World War ! to keep mud out of the revolver action. The shroud also serves to protect the extractor rod from damage that would put the revolver out of action by bending the rod and or damage the crane assembly. The revolver is somewhat delicate, and although more versatile than the automatic in the ammunition it can handle and the repeat capability of firing, it is more subject to physical damage than other pistols.


How do you removed a tie rod inner for a Pontiac Sunfire?

how do you repair an inner tie rod for a 96 Pontiac sunfire no repair,replace with new.


How much does it cost to repair or replace a rod on 1996 Volvo 960?

how much will it cost to replace or repair rod for 1996 volvo 960?


How do you repair piston rod?

you dont. have it replaced


How much does it cost to repair 1999 Nissan Altima Tie Rod?

It can cost between $70 and $150 to repair the 1999 Nissan Altima Tie Rod. It will vary based on where the parts are bought and who makes the repair.


Do you have to replace the engine if you break a rod in the Chrysler sebring?

Usually, yes. A broken rod normally damages the engine block making repair impossible.Usually, yes. A broken rod normally damages the engine block making repair impossible.


What is the purpose of a light bulb extractor and how does it work?

A light bulb extractor is a tool used to safely remove a light bulb that is stuck or broken in a fixture. It typically consists of a long, slender rod with a gripping mechanism at one end. To use it, the extractor is inserted into the fixture and the gripping mechanism is used to securely grasp the base of the light bulb. By turning the extractor, the bulb can be safely removed without damaging the fixture or risking injury from broken glass.


How do you repair a knocking sound in a 1991 Toyota Corolla that sounds like a connecting rod or push rod?

If it is a connecting rod or bearing--be prepared to put in a new motor


How hard is it to reapaur a trucks rat rod ?

The difficulty of the repair depends on the extent of the damage. It is best to have a certified mechanic make this repair.


How do you clean 44 mag rossi?

Clear the revolver of any ammunition. Use a cleaning rod with a bore brush and powder solvent, scrub the bore and the chambers, let set for a few minutes. Remove brush from rod, replace with patch holder tip, pull clean cotton patches through the bore and chambers. Use patch wet with solvent to wipe the face of the cylinder, and inside the frame where the cylinder fits. Add one drop of oil to the extractor, wipe outside of gun with a clean cloth, lightly oiled. Contact Rossi Customer Service, get an owner's manual. A basic cleaning kit should be available at any gun shop, most sporting goods store, Walmarts, etc.


How do you repair a thrown rod?

you cant repair a thrown rod...it has to be replaced...as far as how to replace it, you should be able to get some sort of manual at your local library for removal and installation procedures if not try autozone or search the internet for the repair manual. it is a bit too in depth to be described on wiki answers (^_^)