answersLogoWhite

0

What else can I help you with?

Related Questions

What is the material for a M16 Bolt?

The M16 assault rifle's bolt and bolt carrier are made of steel.


How you find the pcd of flange?

PCD (Pitch Circle Diameter) is the diameter of a circle that goes through each of the bolt holes. You can find it by measuring distance from centre of one bolt hole to the centre of opposite end bolt hole...


What is the standard size of a 3/8 bolt hole?

The standard size of a 3/8 bolt hole is typically 0.40625 inches in diameter.


What is m16 grade 8.8 bolt?

A bolt.


What size hole should be drilled for a 3/8 bolt?

To accommodate a 3/8 bolt, drill a hole that is 3/8 inch in diameter.


How do you measure lug patterns?

On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.


How much does a M16 bolt weigh in average?

A typical M16 bolt weighs around 0.28 ounces or 8 grams.


How can I securely fasten a carriage bolt in wood?

To securely fasten a carriage bolt in wood, first drill a hole slightly larger than the bolt diameter. Insert the bolt through the hole and place a washer and nut on the other end. Tighten the nut with a wrench to secure the bolt in place.


What are the materials for an m16?

The M16 assault rifle has a 7075 aluminium alloy receiver, steel barrel, bolt, and bolt carrier, and glass-reinforced polymer handguard, pistol grip, and buttstock.


A carpenter has a bolt with the diameter 0.3125 inchesWill the bolt fit in hole made by a drill bit with diameter 0.3 inches?

if the diameter 5/16 inches then you covert the 5/16 into 0.3125 inches. divide 5 by 16=0.3125 which is a little bigger than 0.3! ;)


What is the stock subwoofer size in a Oldsmobile aurora?

measure the diameter of the hole for the speaker/subwoofer and the distance to each bolt hole to asure you get the right subwoofer to fit properly.


What is the recommended installation method for a 1/4 hanger bolt in a wooden structure?

The recommended installation method for a 1/4 hanger bolt in a wooden structure is to pre-drill a hole slightly smaller than the bolt diameter, then screw the hanger bolt into the hole using a wrench or socket tool. This will ensure a secure and stable connection.