0
What else can I help you with?
Where is the model number of a Smith and Wesson 357 mag snub 2 in stainless barrel?
Look on frame inside the cylinder area to find the model number of a Smith and Wesson 357 mag snub 2 in stainless barrel
How do you get off the barrel to a 357 magnum smith and Wesson?
You take it to a gunmsith.
What is the value of a 357 smith and WESSON WITH 4inch barrel?
20-1000 usd
What is the value of 357 Wesson with 4 inch barrel?
50-1000 usd
What is the barrel gap for a Dan Wesson D 11 357 mag?
0.006 inches
What is the value of dan Wesson 357 magnum with interchangeable barrel?
Depends on WHICH Dan Wesson .357- there are several- and which barrel(s)- and always, the condition. May range from $200-$500- and without more info from you, we can't even make a good guess.
What is the value of a smith and Wesson 357 model 60 2 inch barrel?
100-300 USD
How much is a smith and Wesson 626 357 magnum 6inch barrel worth?
50-500 usd
Value of a 1976 dan Wesson 357 magnum 4 in barrel?
100-1000 depending on specifics
What is value of dan Wesson 357 magnum from 1976 4 in barrel?
100-1000 depending on specifics
What is a smith and Wesson model 686 357 mag 4 barrel worth?
50-600 usd
Dan Wesson 357 magmum ctg with a 2 barrel how can you tell if it will enterchange to different size barrels?
Dan Wessons have a nut inside the front of the barrel that has to be removed to remove the barrel shroud and barrel. Keep in mind that Dan Wesson barrels are two pieces, the barrel itself, which is just a rifled tube that is threaded on each end, and the outer shroud. Once the barrel nut is removed the shroud just slides off and the barrel can be unscrewed from the receiver. When you put another length barrel on the gun you just screw in the new longer or shorter barrel tube, slip the shroud in place and tighten the barrel nut to hold everything in place. There is a special wrench that is designed to remove and add the barrel nut. You also need to be careful and measure the gap between the cylinder and the force cone of the barrel. DW makes a gauge to adjust this properly. If the distance is too small the cylinder can bind as it turns. A too-large gap effects accuracy and can be a safety problem.
