You're going to need the services of a competent gunsmith for this one.
why wont chu burn in he** and suck the devils cock
Sounds like the catch mechanism is broken.
if i was you, i would ask her. Maybe she doesn't like doing it anymore, sit down and talk to her about it.
cross bolt, half cock, and transfer bar. the cross bolt does just that, you push a safety button and it pushes a pin into the bolt and locks it there. the half cock is usually used on lever actions and single action revolvers but is on others as well, there are 3 positions on the hammer, full forward, half cock( the position is questionable) and full cock, the half cock just makes it so the hammer is back and locked so it cant be fired, but it can be relieved by pulling the trigger, but it is far enough back so it wont get enough forward momentum to ignite the primer. the transfer bar is used almost exclusively on handguns, usually revolvers, it slides a small mental plate in front of the firing pin so the striker cant hit it.
You should reassure her that you wont blab that's probably whats shes afraid of.
The buffer may have denigrated and the inner parts are out of alignment
Need make , model of "gun" hi-point c blue 9mm se
Your hand might be broke or bent. Check with a gunsmith.
YOU ask him out, unless he's fast enough and asks you out, but still, YOU need to take the initiative, and if you don't know what that means then look it up! But if u dont suck his cock fast he wont
YOu need the services of a gunsmith
Pull the trigger. You probably accidentally pushed it forward while replacing the clip.
Yes the wet to straight flat iron works..and really good too...i like the fact that you can use while your hair is wet and it wont burn it =D