It is under the cover between the blower and the motor.
how to change belt on snow devil snow blower
the answer is two the larger belt is the drive belt and the smaller of the two is the auger belt.
How to put new belt on
To replace the auger cable on the MTD snow blower, you have to disconnect it from power. Use a screw driver to open the screw and replace the auger cable in question.
Check the tension on the belt that rotates the auger pulley.
why wont the blades/auger on my john deere snow blower turn? first thing i would check is to make sure there isn't a piece of wood or something jammed between the blades and housing. i don't know if your blower is shaft or belt driven. if belt driven check the belt and pulleys. if it is shaft driven try to spin the blades by hand, if they turn free then the shear pin is broke. look for a small round steel pin in the same are the blower shaft attaches. it should go through the shaft all the way from side to side.
A two stage snow blower has the auger up front that moves the snow into the paddles that throws the snow. A single stage just has paddles, no auger.
Replace Angus cable craftsman 3.8 snowblower
Deere"s number for the auger is #M123224 and drive is #M110637 which is 31" x 1/2" and 30" x 1/2" respectively.
removeaugerassyonmtdsnowthrower
Simplicity
I do