answersLogoWhite

0


Best Answer

Yes, definitely. I had to replace the pool liner due to a freeze-induced blowout (in an above-ground pool). When I replaced the liner I used the foam pool coving material, rather than just reshape the sand. The next year, we started having little leak after little leak. Finally, I drained the pool halfway down to try and patch some bigger areas, and when I pulled the liner away from the wall, the pool cove material was riddled with ant tracks around every area that was leaking. I don't know if it was termites from some nearby rotten firewood, or just ants making nests there, but they really trashed that liner.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can ants eat vinyl pool liner below water level?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When do you cut the hole for the return and skimmer when replacing the liner?

when your water level is about 6 inches below the item. when your water level is about 6 inches below the item.


Water behind vinyl liner inground pool?

If you have water behind your vinyl in ground pool liner, you should first lower the water in the pool to normal levels if it is over-filled. Make sure that the vacuum pipe is clear, unclog it if it is not. Once it is unblocked let the water from behind the liner flow out.


What causes wrinkles in a pool liner?

I'm assuming that you have an inground vinyl lined pool. This is a chronic problem with inground vinyl lined pools, and is due to ground water being higher than the level of the water in your pool. The pressure of the ground water is greater than the pressure exerted by your pool water, and the liner floats. A half baked solution, is to wait until the ground is no longer saturated before removing water. The real solution is to provide a way for the ground water underneath your liner to be removed. This can be a passive system with a small pipe going under your liner and allowing the ground water to drain off (but this only works if you can keep all parts of that pipe below the level of the water in the pool-which depends completely on the pitch of the ground in your yard), or an active pumping system which pumps the ground water out to a drain.


Will my vinyl above ground pool be damaged if I drain it but don't take it down and store it this winter?

With a Vinyl Liner you should not empty it OR take it down. It's very hard to get the liner back in place if you remove it. Vinyl shrinks as it ages so you also need the weight of the water to hold it in place. Movement of the liner could also cause older vinyl to crack. Think of an older cars dashboard! To winterize the pool you should lower the water just below the skimmer, plug the return line, drain the skimmer, pump, filter and plumbing and cover the pool with a winter cover.


How can you fix a detached vinyl liner from its spot?

To fix a detached vinyl liner from its spot on an above ground pool, the water will have to be drained from the pool. Then, a marine patch can be placed on the area to re-attach the vinyl to the place where it came apart. Allow this to dry thoroughly before refilling the pool.


How do you clean crystal like algae from vinyl pool liners?

To clean algae from a vinyl pool liner after it has become crystallized, use a solution of bleach and water with a scrub brush. One cup of bleach for every 5 gallons of water should be enough to clean the vinyl liner. Rinse well, then let dry before storing the pool.


How do you drain water out of a pool?

If it is a vinyl liner pool you have to use a submersible pump. You can get a small one for right at $100.


I am a bricklayer about to build my own swimming pool using reinforced concrete blocks Does anyone have a pool made from concrete blocks PLEASE USE THE WORD I IF YOU ARE TALKING ABOUT YOURSELF?

How are you planning on making the pool water tight? If you want to use a Vinyl Liner, you should consult the dealer you are planning on ordering the liner from. A lot of Vinyl Liner manufactures will not make a liner for that pool.


How do you remove wrinkles from the bottom of an in-ground pool and why are they there if the pool is new?

Hydrostatic pressure or poor water chemistry. If the watertable is high the liner will float and when the water recedes will create a suction and pinch the liner. If your alkalinity and stabilizer levels are low the sanitizer will not have any molecules to attach to so it goes after the vinyl. The pulls the plastizer out the vinyl and causes it to prematurely fade and wrinkle.


What do you do to get water out from under liner of a vinyl lined pool?

I just had this happen. I have an in-ground vinyl pool. About 10,000 gallons of water was under my liner this weekend. I took off the trim ring around the (normally summerged) pool light and slipped a small submursable pump with hose attached under the liner at the deep end. Plugged in the pump and let it run for a day - got almost all of it out. I used a Rule brand pool cover pump, but any small submersible pump will work.


What is the meaning of liner?

Regarding pool: a liner refers to an in-ground or above ground pool that uses a Vinyl Liner to hold the water. The liner is a custom fit to the shape of the pool, in-ground pools utilizes steel, or composite walls to hold the earth back and the floor can be a thin concrete or a sand bottom.


Can a vinyl pool be placed on brick and or concrete?

You mean a cover like to close the pool over top of the water or a liner to hold the water. To cover over the water, some companies make vinyl covers, they tend to be more expensive and heavier then woven ones though. As far as a liner, some manufacturers choose not to make Vinyl Liners for concrete pools for different reasons. You'll have to check with a dealer in your area to find a supplier that does, or pursue other repair options.