0
Can you attach a PVC pipe to a ceramic pipe i found a crack in my sewage drain and i was wondering if i could replace a section with PVC piping?
Wiki User
∙ 15y ago
Yes, you can attach PVC pipe to ceramic pipe with a fernco. You just have to make sure the inside diameters of the fernco match up with the pipes you are joining.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can adhesive be used to attach ceramic tile to drywall?
Use a good mastic or adhesive
What glue is best to attach pottery or ceramic to steel?
PL200, or any epoxy.
What is the small section of a chromosome where sister chromatids attach to each other?
Centromere
What is the weight of a ballistic vest type III?
it weighs approximately 55-65 pounds depending what you attach to it, if you have a trauma plate, and if you include ceramic plates. the trauma plate weighs about 3 pounds, the ceramic back plate weighs 30-45 pounds and the front weighs 25-30 pounds.
How are the fence wires connected on a Sentry 2000 charger?
There are 2 bolts which protrude from the bottom side of the charger. Attach the left side bolt to your ground post with a section of wire. Attach the right side bolt to the fence with another section of wire. (That's how mine is set up.) Easy to use.
Do i have to replace front bumper to attach winch on 1997 Cherokee sport?
With most winch kits, yes.
How do you replace the rear view mirror on a 1995 Nissan sentra?
Use strong glue to attach mirror
Why does the horn go off on my Volkswagen 1997 Jetta when I replace the battery?
Its a Power Surge When you attach the new battery.
How do you turn a bathtub spout into a handheld shower?
Replace the spout with one that has a place to attach the hose for the hand held.
How do you replace the intake manifold gasket on a 87 d100 slant 6?
remove the intake and exhaust manifolds. there are bolts that attach them onto the head and there are bolts near the carburetor that attach the intake manifold to the exhaust manifold.
How do you replace a door pin on 1999 jimmy?
you dont, the doors are welded to attach them. dealers set them for around 100 bucks.
How do you change the coil resistor on a 1988 raider?
the coil resistor is a ceramic block on the top of your coil, you just remove the wires attach to it, put some grease on the bolts(on the new one) that attach the wires, and put it back together, to see if your resistor is faulty, just run a wire from 1 pole to the other, make sure you have a good contact.
