Yes. It depends on the fixture. If the bulb runs at line voltage (i.e. without a transformer), then yes. If it's a low voltage halogen bulb, such as a 12 volt running off of a transformer, then you'll need to find out if the transformer is dimmable.
Most ordinary fluorescent lights can't be dimmed. You need to look for bulbs and fixtures that are specially designed to be used with a dimmer.
Only some can. Most cannot and if it is an older one - no way. They will say that they are rated for dimmers. Be careful with that!
If you are talking about the lamp then the answer is no. If you are talking about the fluorescent fixture, it should be. It is the fixture grounding that helps the tube to ignite. because of the close proximity to the metal of the fixture. There are many occasions when the fixture will not operate, but as soon as the ground is connected the fixture operates fine.
Yes a black lamp tube will work in a fluorescent fixture. Guess you don't remember the early 70's.
you can not put a normal dimmer on a florescent light. You need to install a dimmer made for flourecent lights and they are expensive about 50 dollar around here. If you want to dim it put a normal incandescent bulb in the fixture.
It is unlikely that actual light fixtures will be going away any time soon. Fluorescent bulbs will eventually be obsolete as LED and newer technologies take over.
A fluorescent light fixture is designed to operate on an AC voltage supply. To have the fixture operate off of a DC supply a power inverter would have to be installed. The power inverter would then change the DC to AC for the fixture to operate. These power inverters are reasonably priced these days and can be bought at most DIY stores.
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
Yes, if it fits the socket and the light fitting, or lamp fixture, with its cover or shade. You will not be able to dim the compact fluorescent as you did the incandescent (unless you have a really fancy dimmer).
No, the fixtures do not have anything is common other that emitting light. If you are talking about removing the fluorescent fixture and installing a new fixture that can take a LED lamp then the answer is yes.
If you are talking about the lamp then the answer is no. If you are talking about the fluorescent fixture, it should be. It is the fixture grounding that helps the tube to ignite. because of the close proximity to the metal of the fixture. There are many occasions when the fixture will not operate, but as soon as the ground is connected the fixture operates fine.
Old fluorescent light do not explode. It will go only dimmer and dimmer or sometimes flickering and flashing on/off when it is defective.
Yes a black lamp tube will work in a fluorescent fixture. Guess you don't remember the early 70's.
not orden araly
No, the ballast's output is not matched to operate a fluorescent bulb.
You need to purchase a Fluorescent dimmer switch, no circuit can dim the brightness of the light safely.
I have but if dimmer is on low the light fixture sometimes "hums", can be anoying It also shortens the bulb life, significantly in some cases. But their are also CFL bulbs built to be used with a dimmer switch that avoid these problems.Another AnswerYou should only use CFLs specifically-designed to be used with dimmers in circuits controlled by dimmer switches. There is a proven danger of fire hazard when ordinary CFLs are controlled by dimmer switches and, so, this should NEVER be done.
The basic fluorescent light fixture is AC, although there are fluorescent lights powered by DC.
There are at least 50 different possible sources of perceived interference to an FM radio. Most likely is electrical noise from a nearby motor, fluorescent light fixture, or light dimmer. That's my opinion; I could be wrong.