No, carpet pad is both taller and softer then pads meant for floating laminate and wood floors. No pad of any kind should be used on any other type of wood installation.
Generally, no. The carpet pad will have too much bounce causing the engineered hardwood (or even laminate) to break and split. That being said there are some thin felt carpet pads that could work, but I wouldn't recommend it. I'm not sure why you are asking this question. If it's because you had carpet there and you are hoping to reuse your existing carpet pad, that is a big no no. The carpet pad will be uneven which can cause problems and worse than that, it will already be dirty with germs and potentially moisture and you could develop mold and/or odor issues. Also, if your engineered hardwood is over concrete, you want the traditional laminate/hardwood underlayment which also has a moisture barrier. This, of course, is assuming that you are doing a floating floor. If you are nailing or glueing than it's an even firmer no.
NEVER, The heat will break down the finishes over time. The same is true with vinyl flooring, hardwood, laminate, LVT and grouting. Steam is meant for carpet only!
Nope, you need to take out the old one, i believe. Edit - No, I disagree with this. This depends on the situation. If you have a hardwood floor installed on top of plywood, it is generally better to remove the hardwood and replace it. But, if there is no subfloor (and this is sometimes the case in the older homes in our area), then sometimes it is actually fine to install on top of the hardwood. The hardwood (or often pine if it's older) then becomes the subfloor and then you can nail on top of that. It is important, though, that the hardwood is installed perpendicular (or diagonal to that) for better installation. Oh, and it's important to look at heights and make sure there is enough clearance for the wood and that doors can be opened (or shaved).
Interlocking floor tiles are not preferable used over carpet. The best surface to lay tile or any other flooring product is on a firm and solid surface that out give. Carpet goes down when you step on and makes it so the interlocking tiles will eventually come unlocked by stepping on it. I would not recommend that you install any type of flooring until your carpet is taken out. However if your looking for a good interlocking floor tile I would recommend Swisstrax. They have a great product. And they are great to work with. Sources: www.swisstrax.com www.bigfloors.com www.racedeck.com
No, parquet has been known to buckle because he moisture in the cement has nowhere to escape too.
When used with area and Oriental rugs, carpet padding is used to provide an extra cushion beneath your feet, to prevent the rug from sliding all over the floor, and to promote even wear on the rug's pile. For flatweave and antique rugs, carpet padding is a must!
You don't put padding directly on a concrete floor. You have to frame out the floor, lay plywood sheets over the frame, probably want a vapor barrier as well. Then you can lay any pad and carpet you want. There are certain types of carpet that come with an attached foam padding that are designed to lay over concrete. If you think you want to just glue carpet directly to the concrete floor, check the mfg. warranty first. Most mfgs. will not honor their warranty unless they specifically state that it can be glued to concrete.
Generally, no. The carpet pad will have too much bounce causing the engineered hardwood (or even laminate) to break and split. That being said there are some thin felt carpet pads that could work, but I wouldn't recommend it. I'm not sure why you are asking this question. If it's because you had carpet there and you are hoping to reuse your existing carpet pad, that is a big no no. The carpet pad will be uneven which can cause problems and worse than that, it will already be dirty with germs and potentially moisture and you could develop mold and/or odor issues. Also, if your engineered hardwood is over concrete, you want the traditional laminate/hardwood underlayment which also has a moisture barrier. This, of course, is assuming that you are doing a floating floor. If you are nailing or glueing than it's an even firmer no.
Floating Installation This method the floor floats over foam cushioned padding.
If you're installing hardwood floor boards over a strong 3/4 inch plywood sub-floor, then yes, you can install the hardwood floor parallel to the joists. If your sub-floor is weak, then you should fix the subfloor.
Yes, if the padding is worn out or about to be worn out. Other wise if the padding is still in good shape then just leave it and add the new carpet over it.
Yes, you can install a laminate floor system over existing hardwood floors. Just be sure that the existing hardwood is pretty smooth or the hump in the floor will transfer through. You must use a vapor barrier over your existing hardwood to reduce sound as well as moister transfere between two floor systems. Be sure to let your new floor acclimate to your room temp. for at least 48 hrs. this is especially important if you are installing floor in the winter.
No, laminate is floating type of floor installed over an insulation pad. Hardwood floor has to be nailed, stapled or glued to the subfloor. If you do manage to install hardwood on top of laminate sooner or later your Laminate floor will expand due to high temperature or humidity and it will create gaps between hardwood planks.
No, laminate is floating type of floor installed over an insulation pad. Hardwood floor has to be nailed, stapled or glued to the subfloor. If you do manage to install hardwood on top of laminate sooner or later your Laminate floor will expand due to high temperature or humidity and it will create gaps between hardwood planks.
Yes you can as long as you are not concerned about damaging the underlying floor. If the floor is old and the finish in unimportant to you, you are fine. If you are looking at steam cleaning an area rug which is on a hardwood floor, that's a definite no-no and the as the water and steam can stain or buckle the hardwood.
Yes, no problem.
No, the carpet pad moves far to much and your tile will look loose and crooked in a very short amount of time. Also, the carpet pad will not allow the adhesive to bond to it.