I'm fairly certain not, you would need to fabricate motor mounts and get a modified bellhousing and rewire he entire electrical system. I suppose you are talking about the 2.2l non-turbo?
Yes. The block itself is exactly the same as is the transmission mount locations. there are many things that are different electronically between the two motors and computers however.
Underneath the car's engine behind the motor mount.
Is that lumina van or lumina car? BClear. 3100, 3400.
depends on the type of motor it can fit into any 80s threw 70s Chevy scootsdale truck. Chevy camarows and Pontiac firebird. Chevy monti carlos just depends on the type of motor
All of the local box stores have brackets to mount flat screen tv's on the wall. One of the cheapest places I found was the local flea market. They are new brackets at half the cost.
Fog lights use special brackets which sit recessed on a 2001 Chevy Cavaliers bumper. To install the fog lights mount the units into the bumper brackets. Then splice the fog lights into the existing wire harness. Use a switch if necessary.
On both sides of the block, just above the oil pan, close to the motor mount brackets.
Tv brackets can be used to do a few different things, but mainly just to mount your flat screen television on your wall or tv mounting unit. Make sure you mount it tight!
depending on the year you could bolt up a small block Chevy v8 into it if it is tbi injection you could have your computer recalibrated for the bigger engine possibly injectors you may also need to use engine mount brackets from the donor depending on the year you could bolt up a small block Chevy v8 into it if it is tbi injection you could have your computer recalibrated for the bigger engine possibly injectors you may also need to use engine mount brackets from the donor
Plasma brackets are used to mount a television to the wall. The brackets are used for tilting and swiveling about. Most fully articulating mounts provide adjust on three dimensions - swivel, tilt, and extend.
Yes, by using "L" shaped brackets underneath if no cabinet is there.
yes they are the same a 454 will bolt up