Mixing a solvent into a latex typically ruins the product. Expected result is the latex paint turning into gel.
?????????
No, you use water to thin latex paint. Thinner is for oil based paint.
If you are using latex, thin with water. If using enamel, thin with paint thinner.Always read instructions on the can. They always say what to thin it with.
You can mix water into most latex paints up to a point. Usually eight ounces to a gallon. A better alternative is to add a latex paint additive, like Flotrol, that is made out of acrylic resin, that doesn't degrade the paint.
What do you mean? Yes, paint on wood trim is typically latex these days. Some older homes may still have alkyd (oil), though. To find out for sure, put a little nail polish remover on a cotton swab and rub it on the paint in an inconspicuous location. It it gets soft and starts to come off, it's latex. Either way, sand it lightly and recoat with the same type of paint and you're good. If you're asking about bare wood, DON'T USE LATEX! The water will swell the grain of the wood. Use an oil primer that is made to take latex topcoats.
If you really want to ... yes. It might cause some issues later but should work for the most part as long as you apply a thin layer of paint. Acrylic house paint is normally a latex paint, so there should be no problem painting over a latex with acrylic. The only exception is if it is a solvent based acrylic silicone type paint. In this case, the coating will melt the latex paint, and if overworked while rolling, mix on the surface, which is normally a driveway or floor, discoloring the top coat.
Yes it can, but not very much.
No, you use water to thin latex paint. Thinner is for oil based paint.
If you are using latex, thin with water. If using enamel, thin with paint thinner.Always read instructions on the can. They always say what to thin it with.
You can mix water into most latex paints up to a point. Usually eight ounces to a gallon. A better alternative is to add a latex paint additive, like Flotrol, that is made out of acrylic resin, that doesn't degrade the paint.
What do you mean? Yes, paint on wood trim is typically latex these days. Some older homes may still have alkyd (oil), though. To find out for sure, put a little nail polish remover on a cotton swab and rub it on the paint in an inconspicuous location. It it gets soft and starts to come off, it's latex. Either way, sand it lightly and recoat with the same type of paint and you're good. If you're asking about bare wood, DON'T USE LATEX! The water will swell the grain of the wood. Use an oil primer that is made to take latex topcoats.
If you really want to ... yes. It might cause some issues later but should work for the most part as long as you apply a thin layer of paint. Acrylic house paint is normally a latex paint, so there should be no problem painting over a latex with acrylic. The only exception is if it is a solvent based acrylic silicone type paint. In this case, the coating will melt the latex paint, and if overworked while rolling, mix on the surface, which is normally a driveway or floor, discoloring the top coat.
Yes, the thinner for latex paints is water, but you should never thin latex any more than about 5%, 10% at the very most.
Yes, the thinner for latex paints is water, but you should never thin latex any more than about 5%, 10% at the very most.
NO
It fails. Paint is developed using tens of millions of dollars and the formulas are pretty exact. On really hot days, you can add a "little" Flo Troll to help keep the streaks down and have it not set up as fast. That's it, no water or anything else.
Its its oil based then; Acetone Mineral turpentine (turps) True turpentine Naphtha White spirit Methyl ethyl ketone If its acrylic/water based then water
paint it with a universal primer such as "BLOCKER" brand first Yes, you can. My preference is to use oil base primer under latex (water base) paint, because in my experience the oil base primer lasts longer. It stays stuck to the wood longer. I think latex primer is basically bogus. I have wasted a lot of time using latex primer and it comes loose and I have to sand it all off and use oil base primer. Latex primer does not work. Just like latex paint sticks poorly to bare wood. Latex paint does not have much "stick" (also called "tack"). It is a thin sheet of rubber, and there is very little "tack" to it to keep it glued to the wood. Latex peels off readily, once you put a knife under an edge.