0
You can but it isn't going to do much, laminate is designed to have a low luster/Shine and the mop & glow will likely look more streaky than shiny.. you are trying to shine a floor that isn't supposed to shine...
It will leave a heavy residue and make the floor look extremely dirty.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you remove mop n glow from pergo?
Use half a cup of Ammonia to one gallon of hot water. Thereafter, use a piece of rag to brush the residue off the floor.
Is Mop and Glo a good product to use on engineered wood flooring?
Mop and Glo is not a good product to use on engineered wood flooring. This because Mop and Glo contains a wax, which can ruin the finish that is already on the floors.
Can you use a steam mop on vinyl flooring?
No reason not to, it won't harm the floor.
How do you remove mop and glow from wood laminate flooring?
After trying many things, my husband finally used amonia and water and a stiff scrub brush...then a towel to wipe is down. That did the trick after lots of elbow grease on his hands a knees! What a mess...will never use Mop n Glo again!
What can you use to take off Mop and Glow off tile flooring?
There are special products to remove no wax wax and you can find them at a flooring store. It is a long and miserable process. You put down the remover and let it soak into the Mop and Glow, then start scraping. I did it to a kitchen floor and was on my knees for almost a week total, with a tooth brush trying to get it all off. If you don't get every bit off, the next time a drop of water hits that floor you will have a white spot again.
Can you use a steam mop on karndean flooring?
Just called Karndean and they say no. Steam can loosen the adhesive.
How can you strip mop and glow?
Most flooring stores have a product specifically for the removal of no wax products like Mop and Glow. But it is a lot of work. That no wax finish can build up to the point that it may take several applications of the remover, a scrub brush and a lot of elbow grease. I was on my knees with a toothbrush in some areas trying to get it all off. And you have to make sure you get it ALL off or your floor will look worse. Answer Ammonia and water may do the trick. Use two buckets: one to rinse the mop and one to get fresh ammonia/water.
Clean smell with bissel steam mop?
You can use the steam mop on any floor, but it is made to work best on hard flooring. Mixing in some scented spray will be fine, as long as the instruction maual does not advise against it. You could use it on soft flooring, but it may not be very effective at cleaning.
Is vinegar water a good way to mop a bathroom floor?
No it will smell awful, use pine soil, mop and glow anything but vinegar or bleach both will smell bad.
Can you use a steam mop on amtico flooring?
Based off of the instructions available for caring for the floor provided by Amtico, it suggests not using steam mops on this flooring. These mops could cause damage to the flooring and cause adhesives to fail.
How do you remove blood smell from pergo flooring?
This is somewhat perplexing. Pergo is a sealed surface. It has no pores to allow blood to absorb. A good careful cleaning with a laminate cleaner should take care of it. Try using a little vinegar and water to help, but don't use to much water or you can ruin your floor.
Can you use a steam mop on your pre-finished bamboo flooring?
Like hardwood and laminate, bamboo should not be steam mopped. Besides the added humidity that causing excessive expansion and contraction of the floor, the frequent temperature changes cause unpleasant things to occur on your flooring. Manufactures almost universally void warranties on flooring damaged by steam mops and cleaners, regardless what the mop manufactures state.
