Diagram for a serpentine belt 1998 ford f-150?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

Serpentine Belt
Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram.
If it is not you can run down to your nearest auto parts store and they can print it out for you or just buy the Hayes or chilton manual on your car. It only cost a few bucks and it well helps you out later down the line if something else brakes.
Relieve Serpentine Belt Tension.
Before removing the belt, note its routing around all applicable pulleys for ease of installation.
1. Using a box end wrench on the tensioner pulley center bolt, rotate the tensioner assembly clockwise.
2. While holding the tensioner in this position, remove the alternator drive belt from one or two of the applicable pulleys.

Use a box end wrench to rotate the tensioner pulley assembly clockwise to relieve serpentine belt tension
1. Slowly release the tensioner, and remove the box end wrench from the center bolt.
2. Remove the alternator drive belt from the remaining applicable pulleys.
To install:
When installing the drive belt on the pulleys, ensure that it is properly seated in all of the pulley grooves.
1. Using the box end wrench, rotate the tensioner clockwise again, then position the drive belt on all of the pulleys.
2. Slowly release the tensioner until it eliminates all drive belt slack.
3. Inspect the tensioner indicator to be sure that the belt is properly tensioned. If the belt tension is incorrect, the belt should be replaced with a new one, or, if installing a new belt, the belt may not be the correct belt for your vehicle.
4. Then start the engine. Ensure that the drive belt works properly.
5. Stop the engine, then double-check to ensure that the belt is properly seated on all applicable pulleys.
6 people found this useful

Where can you get a diagram to install the serpentine belt on 1998 Ford Escort ZX2?

Answer . Using a flashlight, look at the pulley configuration and draw it on paper (rough Idea) then draw a line showing the over and under of the belt, it helped me.. Ans

Where can you find a serpentine belt diagram for a 87 Ford F-150?

Answer . 1-start bu fishing the belt around the fan. These instructions go clockwise. \n2-drape the belt OVER your ALTERNATOR(top p-side) \n3-then UNDER the TENSIONER (to

1998 sunfire gt serpentine belt diagram?

If you don't have a diagram somewhere under the hood, it seems that diagrams can be hard to come by. If the belt is still on the car, make a quick sketch of it's routing. Y

Diagram for a 1985 Ford F-150 serpentine belt with ac?

Watch how the old one comes off. Also there should be a diagram under the hood somewhere. Check on the fan shroud. Might also be off to one side. My 89 had a sticker diagram r

Serpentine belt diagram for 1998 expedition?

Serpentine Belt Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate

Where can you find a serpentine belt diagram for a 2004 ford F-150?

Serpentine Belt Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate

1998 Ford Expedition serpentine belt?

Serpentine Belt Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate