answersLogoWhite

0


Best Answer

You should be able to remove the header pipes and get the oil pan off. After that, changing an oil pump is not that bad. If you have room to drop the oil pan, you don't have to pull the engine. sometime you can unbolt the motor mounts ,and jack the engine up a bit. if you do that ,be careful the dist. cap doesn't hit the firewall and break.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do you have to remove the engine to change the oil pump in a 1988 Chevrolet pick up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change a thermostat on a 1988 Chevrolet beretta?

no


What year of Chevrolet truck enterchange with a 1988 silverado 1500?

Engine and engine parts: 1988 to 1995 Body parts : 1988 to 1999


How do you remove the dashboard in a 1988 Chevrolet beauville van?

http://www.vannin.com/


Why does your 1988 Chevrolet Camaro die when you give it gas while idling?

you are flooding the engine


How do you change out a heater core in a 1998 Chevrolet S-10?

if its like the 1988 u would have to remove the glove compartment and it should be right behind that, ask a mechanic to make sure ,


How do you get to the spark plugs to change them on a 1988 Iroc with a 350?

Put the IROC up on jack stands and remove the spark plugs from under the engine.


Where is the oxygen sensor on a 1988 Chevrolet celebrity?

If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.


What is the ignition timing on a 1988 Chevrolet S10 Blazer 2 8 liter engine?

10 degrees


How do you remove the heater core in a 1988 Chevrolet Beauville van?

Get a manual on your van fron the parts store or AUTOBOOKSONLINE.COM


How to Change Engine Computer for 1988 Chevrolet s10 pickupwith a 2.5 liter Were is the location of the Engine Computer?

the computer is located under the glove box. You simply change the computer with another one with the same code. The whole job should take you less than 1/2 hour.


Do you have to remove the trans when you replace an engine on a 1988 Nissan Pulsar?

no u do not


What is the firing order 1988 Chevrolet 2.5?

The firing order for the 2.5L engine is: 1-3-4-2