0
Do you have to turn off the water pump for the pool during the day in summer time?
Wiki User
∙ 11y ago
No, but it helps save electric.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Intex Pool Pumps?
form_title= Intex Pool Pumps form_header= Swim your summer away after you buy an Intex pool pump. What is the square footage of your swimming pool?*= _ [50] Is your pool a salt water pool?*= () Yes () No How often do you clean your pool?*= _ [50]
How do you prevent water from collecting in your pool during construction?
Install a tarp to cover pool construction area. Install small sump pump at bottom of pool area
What is the name of pump that you can pump water out of a pool or ditch?
A Bilge Pump is what it is referred to on ships when you pump water over board. Trash pump.
How do you hook up saltwater pump to an intex pool?
how do you hook up the cleaner to salt water pool pump
How long should pool pump filtration time be during summer and winter months for saltwater pool Does extra hours of operation wears equipment out How about electricity cost per hour save?
ne hour
Will it damage the pool pump or filter to let the water level drop?
So long as there is water coming through the pump when it is running it doesnt matter what the water level in the pool is.
In ground pool was covered in ice after the pump stopped running during a hard freeze and now the pump has been replaced but the system will not start up why?
Perhaps the pump needs to be primed with water.
How do i keep my in ground swimming pool from holding water?
Pump the water out or put a cover over the pool.
When the pool is not being used for an extended period how long should the pool pump circulate the water?
It depends on the season. In the winter, you can get by with 4 hours circulation. Normally, in the summer you need around 8 hours of circulation. If you are thinking about not using the pool in the summer, you may can reduce to 6 hours. Pool is still at risk for algae, even if no one is swimming.
How can you return water out of your pump into the pool?
There are just a few easy actions you need to take to get the water from your pump back into the pool. Before anything else, check that the pump is wired in and primed. Make sure there is nothing clogging up the pump basket. Find the pool's water return inlet and proceed to the next step. This is a fixture that is typically installed on the pool's wall. Pool hose of an appropriate length should be attached to the pump's discharge port. The pool's return inlet should be connected to the hose's opposite end. When you're ready, activate the pump. After a while, water should start trickling through the hose and into the pool. Check for leaks in the plumbing and make sure the water is flowing freely. If the water flow rate is too slow or too fast, you can adjust the pump's settings. Proper water circulation and filtration rely on routine pump and pool equipment maintenance.
Is it normal for the pool pump to fill up with water while the pool is still filling up?
Certainly, if the pump is running. The primary pump intake is the main drain at the deepest part of the pool.
How is an above ground pool pump different from an in ground pool pump?
In simplest terms, an above ground pool pump is a flooded suction pump, which means the water level must be higher than the pump for it to operate, and an inground pump has the ability to draw water up from a level lower than the pump. The engineering and structure of these two different types of pumps is what makes them work the way they do. This means that, in a typical installation, you could use an inground-specific pump on an above ground pool, but not an above ground pump on an inground pool with the water level below the pump.
