No you do not.
If you have a lava lamp turned off for at least 2 days or less then it won't be as hot. hope this works. - Lola Parks
One lamp won't do much. I have 10 and my room is always really hot when they are all on
A microwave releases only micro waves. It doesn't release any harmful radiation. The only harm a microwave can cause is if you put certain items that can make it explode (like a lava lamp, dont try that please).
If the bulb is switched off, then we would call it non-luminous.
They all contain Sodium which gives off a unique orange glow when heated.
it spills
No!
If you have a lava lamp turned off for at least 2 days or less then it won't be as hot. hope this works. - Lola Parks
unplug the bulb from the lamp and pull the lamp off of the lamp adjustments (might take a pretty hard tug)
Turn the lamp off. As it cools, the wax (goo) becomes more dense and will fall to the bottom.
One lamp won't do much. I have 10 and my room is always really hot when they are all on
1- take bumper cover off. 2-disconnect bolts from behind headlight assembly in engine compartment and from inside of wheel well to assembly. 3-twist cap rear cap off, flip clips holding lamp assembly in place, and pull out lamp. 4-im still learning how to check the ballst.
all you should have to do is take the distributor cap off, and there it is. answer take the distributor cap off, pull the old rotor off, put the new one on, put the cap back on.
no
A hypothesis for a science project is a proposed explanation made on limited evidence as a starting point for the investigation. The best hypothesis for a science project of a lava lamp would be based off of the given information and a prediction of the result of the investigation.
1.Put in red 2.Put on cap 3.Put in chemical 4.Take cap off 5.Rotate five times 6.Put on cap 7.Put in chemical 8.Take off cap 9.Rotate once 10.Put on cap again 11.Put in chemical 12.Take off cap 13.Rotate twice 14.Put on cap 15.Put in red 16.Put in chemical 17.Take off cap AND YOUR DONE
You have to pop the cap off on the front of the acrylic handle, then under the cap there will be a screw to undo.