OBD1 code 36 is a high res failure. Due to a bad or failing
optispark distributor. My 95 has this same code and still runs but
the optispark is not sending a signal to the pcm. If I crank the
engine for about 7 seconds it will start every time.
Wiki User
∙ 16y ago
This answer is:
👍 Helpful (0)👎 Not Helpful (0)
Add a Comment
Add your answer:
Earn +20 pts
Q: Engine stalls after warm up. code 36 apears on scan tool also cooling fans both run instantly it starts again immediately then check engine light turns on. ecmdist stunning. its a 93 z28 code P?