When you say holdhold supply of 230volts, you are referring to the RMS value, not the peak value.
RMS
Yes just connect any line to neutral you have 230volts already.
It depends on the periodic time of the supply which, in turn, is determined by the supply frequency. So, work out the periodic time of a 50 or 60-Hz waveform, and go from there.
If electricity stops flowing to one part of the house, it continues to flow to the other parts.AnswerAll household circuits are connected in parallel with their supply voltage. This ensures that (a) all loads are subject to the same voltage, and (b) if one load fails the others continue to work.
The answer to this question depends entirely on where you live. All voltages quoted are 'nominal', or 'named', voltages and not the actual voltage as you would measure it with a voltmeter. National regulations stipulate how much these nominal voltages may vary.For example, in the UK, the nominal voltage is 230 V, and the allowable variation is between -6% and +10%. So, the maximum (actual) allowable voltage is 253 V.In some residences, e.g. Cyprus, a three-phase supply is common for residences, in which case the maximum nominal line-voltage is 400 V, with a nominal phase-voltageis 230 V.
The maximum amount of time for a script to execute was exceeded. You can change this limit by specifying a new value for the property Server.ScriptTimeout or by changing the value in the IIS administration tools.
The maximum supply voltage per the data sheet is 5.25 volts. This is a common max for TTL type IC's.
+or- 5%
Clipping occurs in the voltage waveform when the input voltage, multiplied by the voltage gain of the op-amp circuit, exceeds the op-amp supply voltage as limited by the output network. The supply voltage and output network, limits the maximum voltage that can be achieved at the output. The op-amp behaves normally within its range of maximum voltage output, and then it is clipped when it reaches the maximum voltage of the circuit.
Yes just connect any line to neutral you have 230volts already.
The household supply in the UK is 240 V and is AC (alternate current).
AC voltage is 220v in Germany.Normal household appliances are 240v, some dual phase appliances such as cookers are 400v.
It depends on which country that you live in. European and UK, the household voltage is 230 volts. In North America, the household voltage is 120 volts. Other countries around the world, the blankets that are sold will match the household supply of that country.
It depends on the periodic time of the supply which, in turn, is determined by the supply frequency. So, work out the periodic time of a 50 or 60-Hz waveform, and go from there.
Maximum induced voltage occurs when the current is changing at its greatest rate -this occurs when the current passes through zero. Since this voltage acts to oppose current flow, this maximum voltage acts in the negative sense when the current is acting in the positive direction. Since the supply voltage is equal, but opposite, the induced voltage, it is maximum when the current is zero -so leads by 90 degrees.
When a surge occur, it peaks at above the maximum supply voltage, like in the event of a lightning strike for instance. This can damage household appliances that are designed to operate at a certain AC supply voltage. So a surge diverter actually diverts excess voltages to ground to protect appliances. A good link to read is: http://electronics.howstuffworks.com/everyday-tech/surge-protector1.htm Enjoy
The voltage marked on a capacitor is its MAXIMUM SAFE WORKING VOLTAGE. The capacitor will work in a circuit at any voltage lower than that, but it may fail at any higher voltage.
A variac a variable auto-transformer, allowing the output voltage to be adjusted from zero up to a maximum voltage, which might be 20% greater than the supply voltage.