0
The bend in the pipe can be ignored as long as the drain is even at the floor. The pipe can be coming out of the floor at an angle and it will still work. Cut the pip flush with the floor and use a metal floor flange screwed down to the floor. The flange and the pipe do not need to be joined together, the wax ring will make the connection.
Wiki User
∙ 13y ago
Wiki User
∙ 15y agoThe same way you install one NOT in a corner. As long as the rough-in is correct, it should install just like any other.
Add your answer:
Earn +20 pts
What can the waste pipe bend clearance be through floor for toilet closet?
6 foot
Toilet Repair Mission Bend TX?
Toilet Repair Mission Bend TX
Why doesn't boys bend down to use the toilet?
Because of differences in plumbing it's easier not to, if urinating. If defecating, they do bend down.
What are pliers?
Pliers that are bent along their length to get in awkward spots. I have 3 that bend 30, 45, and 90 degrees.
What are cranked pliers?
Pliers that are bent along their length to get in awkward spots. I have 3 that bend 30, 45, and 90 degrees.
What is the part of a toilet that's called a slang?
The part of a toilet that is sometimes referred to as "the slang" is actually called the "U-bend" or "P-trap." This is the curved pipe under the toilet that holds water and prevents sewer gases from coming back into the bathroom.
What muscle bends the arm?
The muscle/muscles that bend your arms are called Flexor and Extensor.
Can the drains for a shower and sink come before the drain for the toilet Example the sink and shower then comes toilet then enters main stack?
In my experience I've seen this type of scenario in older buildings. Usually the sink will tie into the stack in the wall while the shower generaly connects in below the toilet also known as the closet bend. In alot of older houses and apartment complexs they have tied multiple drains together in a smaller pipe before going to a larger one. For example the lav with the tub, the kitchen sink with a tub, or all three together.
In plumbing what is a trap?
A trap is a bend in the pipework that keeps a constant level of water in a drainage or waste system. This stops smells and fumes coming back up the drains and through your plug hole or toilet pan. Types of traps are bottle traps, P traps and S traps to name a few. Hope that helped :)
Can water enter through roof vent pipe?
Of course if someone did not install a return bend or a vandal proof cap
How does sitting on the toilet prevent constipation?
Sitting on the toilet for 10 minutes at the same time every day, preferably after a meal, can induce regular bowel movements. This may not become effective for a few months, and it is important to defecate whenever necessary.
How do I Lower water level in toilet bowl?
YOU DON'TIt is pre determined by the seal of the trapBasically when the toilet is designed the volume of retained water at the bottom of the toilet is calculated so that it stops effluent gasses coming back up the stench pipe in to the toilet and also to stop waste that goes down sticking to the bottom of the bowl.
