1. heat. If it's hot enough, blackbody radiation (e.g. incandescent light bulb)
2. Electromagnetic radiation (radio waves, magnetic or electric coupling to adjacent conductors) if the current is changing.
They don't lose their energy. Free electrons pass the current through the conductor, but don't move far themselves, and are still there when the current is switched off, waiting for the next switch on.
the electrons are current carrier which flow from negative to positive potential. This makes the flow of current . the direction of currents is opposite to direction of electron flow .Hence any circuit can be operate by using electrons or respective charge carrier it may be hole. (current flow).
Electrons are pushed by what is known technically as electromotive force; this can be measured in volts.
Current measures the flow of electrons through a circuit and voltage basically measure the amount of available electrons.
a parallel circuit.
The free electrons flowing in the circuit decrease.
series circuit
When you start at the negative end of the battery, you start to lose electrons and the circuit is closed.
The load that is connected in a circuit is what does the work in the circuit.
Nope... if the circuit has a gap in it - the path of electrons is interrupted, and that would stop the circuit from working.
A switch allows the circuit to have a break in it therefor making it not work. It stops the flow of electrons.
A closed path through which electrons flow is known as a circuit.
a path of continuous electrons. may include switch but must have load or will short circuit.
Electrons move in a circuit and have millions and millions of collision's.
an open circuit allows electrons to flow constantly
An electrical circuit is a path which electrons from a current source flow. Electric current flows in a closed path called an electric circuit. The point where those electrons enter an electrical circuit is called the "source" of electrons. The point where the electrons leave an electrical circuit is called the "return". The exit point is called the "return" because electrons always end up at the source when they complete the path of an electrical circuit. The part of an electrical circuit that is between the electrons' starting point and the point where they return to the source is called an electrical circuit's "load". ---Nerd
Circuits need 3 things to work. They need a load, (what the power goes on) power source, (the battery) and connectors (the wire inbetween). Circuits use electrons to flow from the negative side of the battery and around the circuit back to the battery. This repeats until the circuit breaks.
They reduce the flow of electrons.
No. For electrons to flow, you need a current.
it is a seriues circuit