REMOVE POSITIVE SIDE OF BATTERY CABLES BEFORE BEGINING>>>JUST IN CASE!Hing the ash tray lid open...take the 2 Phillips head screws out...on bottom of cover remove the 2 phillip head screws...pull cover back 4 inches to remove the lighter socket plug and power mirror plug (if so equipped). Now you can safely remove the plastic portion of the cover. Now on to the metal cover. On each side of the cloth heat cover remove the 2-3 snap covers then remove the phillip head screws. On the very bottom of the metal cover feel the carpet for raised areas...under the carpet are 2 bolts on a hinge (use 1/2 socket on 10 inch extension with 3/8 ratchet) no back to the sides of the metal cover...there ia a clasp hinge on each side...lift the rear of the clasp (furthest side away from dash) and slide back.
My 93' vandura has a 5.7 liter 350cubic inch engine.
hydromatic 400
1993 Vandura motor sizeGet VIN number from the vehicle, call your local Chevy dealer parts department, and he can identify which engine is in your vehicle from the VIN. They usually had a 5.0 liter(305 cu.in.), 5.7 liter(350 cu.in.), which was most common, and a diesel was available. *My 93' Vandura has a 5.7*
there are actually 3 fuses ( that i have found) 2 are in the fuse panel below and to the left of the steering column marked ac and auxilary ac/heat. my 1993 g3500 vandura also has an inline 20 amp fuse wired in between the fuse panel and the rear blower motor switch.
with hood open=Front left side of engine. I allways take my air intake tube off to allow more access.
Inside the reservoir.
It should be behind the rear vent.
There is not one.
Inside that door.
Inside the door.. usually held on by large rivets.
I have a 1995 Vandura and power sofa fuse is under hood. There is a fuse block there too with iterior electronic gizmos on it.
inside gas tank,remove tank.