answersLogoWhite

0


Best Answer

Computer controlled not adjustable

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you adjust idle on 92 grand prix?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a 94 grand prix door fit a 92 grand prix?

yes, the 2 door grand prix uses the same door from 1988 to at least 1996


Your 92 grand prix is running hot?

If your 92 Grand Prix is running hot you probably need to check the oil. If the oil is OK you should check the water and add water if needed.


How do you get in a 92 grand prix?

open the door, sit down, close door?


How much gas does a 92 Pontiac Grand Prix hold?

Sixty liters


Where is the heater core in a 92 poniac grand prix?

Right under the dash in the center.........


For an idle speed motor 92 Expo Mitsubishi?

Idle slows down to a stall when you stop or slow down when AC is running. How do I adjust idle or is something else wrong?


How do you put the spark plug wires back on a 92 3.1 pontaic grand prix?

Push.


Where is the Fuel fiter location on 92 grand prix?

between the gas tank and left rear tire


How do you adjust the idle on a 92 Saturn sl?

IT IS ADJUSTABLE BUT NOT RECOMENED IF YOU HAVE A HIGH IDLE THEN YOU PROBLY HAVE A VACCUME LEAK AND IF YOU HAVE A LOW IDLE THEN YOUR THROTTLE BODY COULD USE A CLEANING OR YOUR IAC IDLE AIR CONTROL COULD BE DIRTY


Your 92 cr250 idles high how can you adjust this?

You can adjust the idle speed on your 1992 Honda 250, motorcycle with the fuel pump adjustment screw. Turning the adjustment screw will adjust the flow of fuel.


How do you set the idle faster on 92 festiva?

AnswerLook for a black cap on the right side on top of the throttle body. Pop off that cap and there will be a screw under that cap to adjust the idle.


How do you replace the turn signal switch located on a 1993 Pontiac Grand Prix?

My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.