it has a switch under the steering column
yes
To change the high beam indicator you have to take the instrument cluster out of the dash.
take the metal trim piece out from around the light with the torques bit and the light should pop out, just unplug it and install new light.
Check the bulb Check to see if you are getting power to the socket
The Low Beam AND High Beam are in the same bulb. The procedure to change it will be in the owners manual.
Change the globe or lamp. H4 type globes contain the high and low beam, so whilst low beam is working OK the high beam part is likely blown.
More than likely it'll be a bottom on the floor board that you push with your foot. 3rd-party edit: the high beam switch is on the wiper arm. Pull it towards the driver to activate/de-activate.l
hi-beam switch is faulty
You Have a bad headlight, it's common when a headlight burns out for only the high beam to work, solution change your headlight.
It is on the signal light switch. Pulling it toward you will change from High to Low beam lights and vice-versa 7T77T7
The high beam switch is on the blinker. You either flick it back towards you or push it away from you.
The daytime run lamps are your high beam bulbs with a module that cuts the amount of amperage that just dims the bulbs. Just change high beam bulb.