do I remove steering wheel to change out ignition
Remove steering wheel and signal switch
Remove the airbag and steering wheel, remove the torx screws from the steering housing and remove the housing, remove the screws from the signal and wiper switch, and remove the screws above the ignition switch and remove the switch. Replace the switch and replace everything in reverse.Ê
You will have to remove the steering wheel and everythin that surrounds the steering column in order to get the ignition switch out. I would suggest getting a good repair manual as this is not an easy process to describe without pictures and such.
you must remove the steering wheel and turn signal from column. then you can acces the screw to remove the switch.
See Q: How do you remove Steering wheel lock VW golf mk2?
First unhook the battery. Then put the key in (you need it!) and turn it to "on." Remove the steering wheel and the ignition switch just slides out.
"you can't unless you grind off the bolts from the steering column bracket. Most times people just change the whole steering column because its all part of one unit." Actually, you can do it without grinding the bolts - remove the lower trim panel (below the steering wheel) insert your ignition key and turn it to acc on the bottom of the ignition switch, there is a button you have to push in and you can then remove the switch
To changeÊthe ignition switch on a Hyundai Accent, first, one should remove the switch from the steering column, to which it is attached. From there, the component can be replaced.
remove the shroud covering the steering coloum and turn the key to the on position push in release pin over ignition and pull cylinder out.
You will need to remove your steering wheel and remove all internals. There is a 10mm bolt that holds the ignition in place. When you remove that it will slide right out.
Disconnect the negative battery cable. Remove steering column covers Disconnect the electrical connector from the ignition switch Remove the screw retaining the switch to the steering column
EJ48315: 1. Remove the four screws out of the back of the steering wheel and pull off the front cover / airbag assembly. 2. After removing the nut / washer / sleeve use a steering wheel puller to remove the hub. 3. Remove the turn signal assembly, should be 2 screws this will expose the ignition. 4. Remove the screw that goes through the backside of the ignition and the ignition should come right out.