"you can't unless you grind off the bolts from the steering column bracket. Most times people just change the whole steering column because its all part of one unit."
Actually, you can do it without grinding the bolts -
remove the lower trim panel (below the steering wheel)
insert your ignition key and turn it to acc
on the bottom of the ignition switch, there is a button you have to push in and you can then remove the switch
The 2001 Chevrolet Camaro ignition switch is held in place with a retaining ring. Remove the retaining the ring and slide the ignition switch out. Remove the wiring harness. Reverse the process to install the new ignition switch.
Begin by removing the retaining ring at the top of your 2001 Chevrolet Monte Carlo ignition switch. The ignition switch barrel will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
http://www.automotivehelper.com/topic1054152.htm or Goole "ignition switch replacement 2001 regal"
How change my ignition switch nissan 2001 sentra.
There is none.
No, there is none.
Ok I have just purchased a set of replacement headlight assemblies for my 2001 tundra How do I get to the bolt on the bottom left or right to remove the assembly.
how to ,reprogram the ignition switch on a 2001 Monte Carlo ls
Yes, the 2001 ignition switch for a 2000 Chevrolet Tracker will fit just fine. Other years the switch fits are 1999 to 2004.
how do u disconnect the cable from the back how do you remove the ignition switch from a 2001 Chevy Malibu you have to put the old key in the ignition. then if you feel around on the bottom of the assembly you will find a small almost rectangular button. depress this and then proceed to turn the ignition clockwise. this will move it to the right position and if everything works correctly it will just slide out.
first remove the dash trim around the switch. the trim should just pull off. its held in by push clips. next remove the screw that holds the switch, push in on switch a little then wiggle it out. remove the electrical connection from back of switch, then pull switch out. to install is reverse of removal.
I recenlty got a recall on my ignition switch in my 2000 sunfire and I just took it to the dealer and they did it for free.
remove plastic cover and put key in the ignition and trun look under the key and you will see a hole put a tinny screw driner in the hole and push it up and pull the switch out
See the link for a 2000 location. The 2001 procedure ought to be about the same.
Remove the dash bezel, remove the switch, reverse process with new switch.
ignition switch or key and tumbler.
The ignition switch is bad. Replace it.
( IF ) it has an on / off switch for the passenger airbag the switch will be just to the right of the radio near the bottom of the radio on a 2001 Ford F-150 Insert your ignition key and turn the switch to the OFF position . Hold the switch in the OFF position while you remove your key
On my 2001 Aztek, I could pull the key out when driving. To change the ignition without removing the steering wheel, take the two screws out from underneath the covering behind the wheel. Not the screws on the steering wheel. The cover will lift up but won't come off. Take an Alleen wrench and feel for the hole on top of the ignition (it will be a tight squeeze), and push in. I should also say remove the black or gray cover on the ignition switch (where the key goes in). Once you find the hole and push down on it, the ignition switch will come out.
remove the plastic cover over the ignition switch. remove the immobilizer ring which is over the ignition switch. secure a good key inside the ring with twist ties. set this aside under the cover and leave all of the wires hooked up. now use a standard key without a chip in it to start your vehicle.
do you mean the door or ignition?
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
Turning the steering wheel left to right rapidly while turning the key in the ignition should free up the ignition switch. If this does not rectify the problem it could be with the lever lockout or the key itself.
$109.99 item#IG23401 at schucks.com