the work is easy but needs some time. carfully remove the twitters covers from both sides. then unscrew the top plate on ur dash alowing access to the lighting dash screen itself. un screw the lighing screen, there should be a screw to the right of the screen next to the right tweeter. on getting that screw off. simply slide the screen to the left or take it off the dash carfully not dameging the clock unit. then u will have acess to the speedometer. find screw holding the speedo and unplug it from the back and two green plugs to the side. once done that u can easily take the speedo off. replace it with a (74) i believe light bulb for the one that are burnt.
Jalal. hope that helped. :S
The speedo itself or the wiring to the speedo can be bad. The Speedo and all the dash light flickers. Trans. slip, but when i unplug the speed sensor the trans work ok. I change trans. 2 times, speed sensor, alternator, battery. The problem not gone. I need help
Greg Stern
left side of speedo
you have either a bad speed sensor (check engine light on?) or a short in the printed panel and amp/ voltage reg. on the back of the speedo head. no check engine light on replace/ rebuild speedo head there are speedo shops. if light is on replace speed sensor as the OBD system uses this sensor to. clear codes and happy driving Johnie
The oil change indicator is associated with the embedded kilometering in the computer. If you change the oil before that specific reminder, the light comes up. Normally you can delete it by pressing the button on the speedo panel. You can reach it by placing a long skewer or a thin flat head screw driver through a small hole. You must remove first the rubber cover of this hole on the transparent plastic sheet in front of the speedo display. It takes another 5000 Ks before it comes up again.
There is no speedo cable on a 96, GM quit using them in 1987. You have a speed sensor, which is located on the top rear of the transmission. It will have a couple wires coming off it in a plug, that run thru the computer, then to the speedo. If your speedo has quit working, has it also set a check engine light? If so, I would recomend replacing the speedo sensor.
You can remove the speedo assembly and remove the bulb, problem solved. You can remove the speedo assembly and remove the bulb, problem solved.
replace your speed sensor
Nadine heimann
Is your speedometer not working? If your abs light or tracs light is on it may be the brake control module causing your speedo not to work.
Check engine is on BECAUSE the speedo is inop, assuming it was not on prior to speedo malfunction. Speedo is electronic. Could be numerous reasons ( no fuses are involved). Could be something simple like an electrical disconnect at transmission. Good luck
eat a light meal