If it's anything like my 92 bird, to replace the signal lights you just pull back the carpet in the trunk and twist the deal that holds the bulb then pull it out.
What if the bulb has broken or shattered but is still installed in the socket??
Almost every car nowadays come with a turning signal. If you do not have a turning signal, a legal way to signal that you are going to turn would be to stretch out your hand in the direction that you are turning to. Otherwise, you can install two lights (flashing or not) on the two corners of your car. Link it to the buttons near the driver's seat for convenience, and press the button to activate the lights as a signal.
they could have burned out, or the wires are bad. I recommend getting it checked by a mechanic ;)
you need to change the flasher can for the signal lights
how do u change front signal lights for corvette 1999
There should be a diagram on the inside of the fusebox cover.
When you are switching lanes and you put you turning signal.
Burned out bulb Faulty socket and/or wiring/ ground Faulty turn signal flasher Faulty turn signal Switch
In most states, YES...You should always signal a lane change on a highway, turning, exiting or entering a freeway. You may get a ticket for failure to signal or unsafe lane change. It also helps other drivers behind you know your intentions and may even help prevent an accident.
No, Flashing your headlight's will have no effect on a traffic signal. The reason a traffic signal changes for emergency vehicles that have the lights flashing, is, they have a special transmitter that tells the light to change. This transmitter is connected to the emergency lights so it comes on when the lights are used.
You may have a "ground loop" problem on the left turn signal. Check the ground wire at the front and rear signal bulbs.
First check the fuse, then the bulbs, then the flasher relay, then the signal switch.
That's the point. So people behind you know you are turning.