0
How do you check the ignition control module on a 2003 cavalier?
Wiki User
∙ 16y ago
I don't think there is a way to check this electrical component other than trying another one. A cheaper alternative is to get a used one at a junkyard and try that first.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
1997 2.5 that has elect to the distributor but not getting any spark?
Check the ignition control module.
What can one look for if there is no spark on a 1991 Chevy cavalier?
Ignition control module, pickup, coil, keyswitch, loose connections. With ignition key on (engine not running) check for 12v (battery voltage) present at Ignition Control Module (pink/black wire) 91 cavaliers use two separate coil packs so check if no spark on all 4 cylinders. Check for a bad Crankshaft Position Sensor (CPS) Should read 800-1200 ohms between the two leads. If it's open or reads very high resistance - replace. It should be putting out a .8 to 1.4 volt ac signal during cranking. If the Ignition Control Module does not see this signal - no spark.
1983 ford bronco wont get spark from the coil any help please?
check the ignition control module.
Can a camshaft position sensor cause car to stall?
it can, but i would check the ignition control module first....then the crank sensor.....
How do you check ignition control module on 93 s 10?
Diagnosing the ignition control module is done with a diagnostic scope. These scopes can range in cost from a few hundred dollars to several thousand, so the most economic way is to take the car to an auto repair shop.
Why does my 1993 dodge stealth has no fire?
check ecm engine controle module icm ignition control module or crank angle censor if is a dhoc distributer if shoc>>>>JAC
Why would a 1993 gmc sonoma 4.3 gets codes 42 and 43?
I can't make any promises, but I've got 94 Chevy using OBD1, like yours probably has too. In my manual this is what it says: Code 42:Ignition Control Module - "Check the wiring and connectors between the ignition module and the ECM. Check the ignition module. Replace the ECM".Code 43:Electronic Spark Control - "ESC module is not receiving a knock signal from the knock sensor. Check the knock system sensor, or the ESC module. Have the module checked by a dealer service department." Hope that helps, good luck!
Where is the Ignition Diagnostic Monitor on a 1995 F-350?
The Ignition Diagnostic Monitor (IDM) information is sent from the Ignition Control Module (ICM) to the Powertrain Control Module (PCM computer). The PCM monitors this information to check on the Ignition System. The ICM is Black in color in 1994 and newer Ford Trucks. Do not use a Gray module as it will cause the PCM to output a code of a missing IDM signal. Auto Part stores have the wrong part listed for these trucks.
Why doesn't my buick reatta have ignition spark?
check your plug wires, then your coil packs, then your ignition module.
How do you Check ignition module 1998 GMC safari?
If you're talking about the module that's mounted on the distributer plate then Orielly's has a machine that will check it.
No spark Ford Escort what should I do?
Please check your spark plugs,wires,distributor and rotor or the ignition coil module. My '93 LX has an ignition coil module.
What else can you check on a 1994 Oldsmobile Achieva that is not firing after the crank sensor boots coil cover and module tested good?
ignition control moduel common problem ..
