0
How do you disconnect a steel fuel line going into a black plastic quick connect on a 97 S10 pickup?
Wiki User
∙ 12y ago
Squeeze together the two locking tabs to release the coupler. Squeeze the tabs first before you start pulling on the coupler. If you can't reach them with your fingers use needle nose pliers.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the ignition signal disconnect on a 93 suburban?
On the firewall under a black plastic cover that has two plastic black nuts
Where is the pcm driver on a Chevy 6.0 HD pickup?
It is mounted in a black plastic box just below the battery. Between the engine and battery.
Where do you connect a timing guns leads on a 1989 Toyota 4 runner?
A regular timing gun has 3 wires, 2 for the power and the pickup lead. Connect red clamp to positive terminal of the battery, the black to neagative, and the pickup to no. 1 spark plug wire, then you're set to go..
How do I retrieve photos from a black Samsung S5 to replacement S5?
Connect the damaged phone to a computer - and copy the files you need to a folder. Disconnect the damaged phone and connect the new one - then transfer the files from the computer to the phone.
Where is the VCM on a 2003 Chevy pickup?
It is called a PCM / powertrain controll module. It is mounted in a black plastic box just below the battery and between the battery and the engine.
When changing the solenoid on a 1998 F150 pickup do the two red cables go on before the black one?
red first, black last is correct. always connect positive cables first and negative or ground cables last
How do i disconnect the horn on a 95 Buick Riviera?
pull the horn relay -- under black plastic cover (fuse relay unit behind passenger headlight in engine bay).
When was Words on Black Plastic created?
Words on Black Plastic was created in 1970.
How do you disconnect the battery from a BMW Z3?
AnswerAfter 1997, the battery is in the trunk. Lift up the mat and remove the two screws on the black plastic top then disconnect the black wire first then the red... lift battery out.... but if you have alarm fitted put your ear muffs on!!! Drop in voltage will trigger it. Undo long screw nearest to you that holds battery in place.
How do you hookup battery charger to a 2005 escalade battery?
Connect the positive (+) Red cable from the charger to the positive (+) post of the battery. Now connect the negative (-) Black cable to a metal part of the engine. Do not connect to negative battery post. Plug the charger in. Unplug the charger before removing the cables. Disconnect the negative cable first.
How do you change a battery?
Disconnect the positive battery cable from the battery, make sure you take off the positive one before the negative one. Then disconnect the negative cable. Remove the clamps holding the battery down. Pull the battery out. Put the new one in. Put the battery clamps back on. (make sure you clean the battery connections. make sure there is no corrosion) Connect the negative cable first, tighten it, then connect the positive cable and tighten it. You are done. disconnect the positive and negative connections ( only 2 connections ) remove battery. replace with new then connect the negative and positive connections to the correct terminals. There is a plastic cover over your battery. Remove the positive cable, then the negative cable (if its stock, then it uses an 8mm wrench). Then remove the plastic cover. On the side of the battery closest to the middle of the truck, there is a plastic "chunk" held down by an 8mm bolt. Use an 8mm socket with about a 10" extension to remove this. Take out the battery and replace using the reverse procedure. It should be replaced with a 65 series battery in your expedition. Note - black is negative. red is positive
How do you attach jumpleads to a citroen Picasso?
under the bonnet there is a black plastic cover on the gearbox side, it has a + symbol on it connect positive jumplead to that and other engine mount or other earth
