What would you like to do?
How do you drain water from the tail lights and rear quarter panels of a 96 Sebring Convertible?
Very small drillbit underneath taillight. small hole water drains out. I recommend sealin the hole with silicone after.
75 people found this useful
Was this answer useful?
Thanks for the feedback!
Removing the taillights To access the taillights one needs remove the taillights cover. To do this open the trunk, in the trunk are three plastic bolts that hold the tailli…ghts cover on. To have easier access to these bolts pull the trunk fabric a little away from the bolts. Unscrew these, then from the outside of the car pull the taillights cover toward you. Once the taillights cover is dislodged from its spot in the body of the car. You should have full access to all the individual lamps once you do this.
Access the trunk, lights are held on by bolts and connected by a wire harness behind the carpet.
In the trunk , drivers side on fender well behind the carpet
Why are there plugs in the drain holes at the from of the rear fender wells on your 1998 sebring convertible?
So that they can be taken out if any water gets into the trunk, and while in place they stop grouind water getting in.
I have an 01 Sebring Convertible, and the only way I fixed my window was the following. I went to Car-Part.com found the part, called around for the window with the attached f…abric. Found someone willing to ship that piece to me. Got it for 1/6 of the dealer price. Found a seamstress and had it sewn in for dirt cheap. Quick fix. Hope this helps.
It is on the lower passenger side of the firewall.
To remove the tail light fixture on a 1987 to 1990 Chevy Celebrity sedan: 1. Inside the trunk next to the quarter panel are 3 nuts. Remove the center nut, it should line up …with the center of the tail light fixture. 2. Pull back on the tail light fixture until the stud clears the body. 3. Pull outward on the tail light fixture to remove a tab from the back up light panel. 4. Twist the appropriate socket counter clockwise and remove it. You can now replace the light bulb. Reverse the process to put the tail light fixture back in place.
Location? Usually at the upper end of the brake pedal (under dash)
My 96 sebring fills with water 3-4 inches when it rains are there any plugs how to avoid getting filled how do you remove water in a sebring convertible?
I have a '98 and had to take a thin flat screwdriver and place it in between the metal rails that are underneath the doors that run along the whole side. There are maybe 4 slo…ts where the rails come together. Mine were clogged with dirt and debris so poking the screwdriver up in between the rails released the water and it has not had an issue since.
They are commonly referred to as filler panels.
Rain leaks onto floor under passenger seat of 2005 Chrysler Sebring convertible through quarter panel how do you unclog quarter panel drain?
Hit the rocker panel with a rubber mallet a couple of times on the passenger side of the car. It should start draining more and more the more times you hit it. Good luck
If your facing the front of the car, they are mounted on the front, over near the left hand side. It is jambed packed full, so you have to look close----they use a dual horn, …so there are 2 of them. I think 1 of them is mounted on the front bumper.
In Chevy Nova
Replace the stock tail panel with a 68 thru 72 panel.Next swap gas tanks the 73 neck faces up above the bumper not downward like the 68 thru 72.The final step install a 68/72 …rear bumper to finish it off.
In the early 1996-1998~ Sebring Convertibles with the speakers above the passenger armrest the grills are simply removed with a thin screwdriver or butter knife. the Phillips …head screws are revealed once the grille is removed. The wire from the head unit clips directly into the speaker, you either pry up or push on the tab that is holding it and pull back. You may want to either clip the connector off if you are not using OEM style speakers, or you may want to purchase an adapter for your new speakers. Replacement is the reverse of removal. You may need to make the clips on the grille back into a point. One has a small hook that holds the opposite tab to make a point. If you cant get the grille back on the tabs have probably come apart and this simple procedure should allow you to reinstall the speaker grille.
Short in the wiring or the lamp holder for the tail light is corroded.
It will need to be done by a shop specializing in convertible tops as the window has curtains that need to be glued to the top. I just had mine done last week and it was aroun…d 425 for glass or I could have had plastic ( which isn't that durable ) for 309. This is a common problem for sebrings as I have seen many with bad rear windows and many with homemade windows using duct tape and plexiglass.