0
To answer this question the resistance of the load is needed. I = E/R.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many watts does an electric drill use?
To figure that out you need to know the Amperage that it draws and what the voltage of the circuit is that you're using. Once you know that you can figure out how many watts it uses by doing simple math. Voltage x Amperage = Watts
When a circuit is inductive the current has what voltage?
This doesn't make sense, "current" is "amperage" so the higher the voltage the lower the amperage, and the lower the voltage the higher the amperage.
What is the relation between amperage and capacitance?
The relation between amperage and capacitance is that amperage is equals to capacitance times the rate of voltage change over time. This voltage refers to instantaneous voltage.
What does volts times amperage equal?
Voltage is equal to amperage time resistance. V=IR Therefore, I'd say voltage times amperage is equal to amperage squared times resistance. VI=IIR Really there's no point in multiplying the two. However, if you were to divide voltage by amperage, you would have the resistance of the circuit. V/I=R
When voltage increase then current will be?
it depends on what type of load. Motor amperage will drop off as voltage rises. loads such as lights will increase amperage with voltage rise.
Will a motorized wheelchair battery power an electric bicycle?
Depends on the voltage and amperage of the battery vs. the voltage and amperage required of the bicycle.
How do you figure out resistance?
Turn off circuit. Then you can use a meter set for resistance, clip onto both ends of the resistor, meter will display the resistance in ohms.If you know the voltage and amperage you can use Ohm's Law: E=IRR=E/IR is resistance, E is voltage, and I is current (amperage)
How do you measure voltage using a ammeter?
An ammeter measures amperage not voltage.
How do you measure electricity and with what measurement?
With kitchen tongs. A mild tingling indicates low voltage/low amperage. Muscular spasms indicate high voltage/low amperage. Unconsciousness sans death indicates low voltage/moderate amperage. Death indicates high amperage. Good luck.
What will happen too amperage if voltage is increased and resistance remains the same?
Ohms Law says Voltage = Current x Resistance. Hence if voltage rises, so will current.
What is circuit amperage?
Generally speaking an appliance (eg tv) is supplied with power so when it is off it has voltage supplied. After yo turn it on it starts to draw power called amperage the voltage doesn't get higheur but the amperage does Amperage is the load being drawn through a circiut
How do you make voltage?
Power (P) = Voltage (V) x Amperage (I) Written as P=VxI or to find Voltage V=P/I Voltage is measured in Volts (V) Amperage is measured in Amperes (Amps or A) Power is measured in Watts (W)
