0
i dont know y
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the power antenna relay located in a 1984 corvette?
Under the rear deck glass. Raise the glass and remove the long molding that surrounds the latch. You'll see it to the left of the latch. Also controls back lights.
Where is spare tire rods for suburban 2000?
I can only answer this for a 2000 Suburban. Lift out the middle tray on the Left side of the truck right next to the third seat. Right next to the left rear side glass. The tools are hidden in the compartment right below the left rear side glass. Hope this helps.
Rear door on 94 cutlass supreme won't lock but actuator is workingAnd the rod linkage is all good.Can the outer lock piece on the door that catches the piece mounted onto the car cause this?
if the door does not latch somtimes the latch has locked lift the door handle and pull latch open
1988 suburban rear window stuck down how do you release it to go up so i can check it out?
The glass has a safety switch so it will not raise when the door is let down. Bypass the switch located right side, close to the locking latch (not the one on the door). you may also have a bad switch on the door. i had both
The rear hatch does not lock on 2002 rendezvous?
May be a BCM glitch or the rear trunk latch there is a recall from gm about the rear hatch latch
Rear access open stays on. So that keeps the inside lights on..then runs battery down on 2004 Yukon XL?
door ajar switch/switches are no good, in the glass latch or tailgate latch, or both. your rear wiper does'nt work either because of this. the switches cannot be purchased seperately, you have to buy the latches as they are integral. have 1 at my shop now, glass latch assm. is 334.37, & tailgate latches are 94.75 ea. hope this helps.
How do you open a Ford Escape back hatch?
Open the rear door like any other--Squeeze the handle. If it doesn't open (and isn't locked), it may need service. I replaced the handle/latch mechanism on my 2002 Escape in late 2009. Check for recall applicabilitiy. Seems to me there is something online about a rear latch recall.
How do you remove the outer door handle on a ford freestyle?
Removal of Rear Door Latch is necessary first. Rear Door Latch Removal: All vehicles 1. Remove the rear door interior trim panel. 2. Remove the access hole watershield. 3. Reconnect the window regulator and window switch electrical connectors and position the front door window to access the glass clamp bolt. 4. Disconnect the window regulator and window switch electrical connectors. 5. Loosen the window glass clamp bolt. 6. Tape the window in the full up position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator track. 7. Remove the interior door handle bolt. 8. Disconnect the rear door latch assembly electrical connector. 9. Rotate the push button rod downward and remove it from the rear door latch assembly. 10. Remove the 3 rear door latch assembly-to-rear door module bolts. 11. NOTE: Make sure that the interior door handle does not get scratched when it is passed through the rear door module. Remove the 8 bolts and position the rear door module aside. FIVE HUNDRED AND MONTEGO 12. Remove the tape and lower the window glass. 13. Remove the scrivet. 14. Remove the rear door glass run top bolt. 15. Remove the rear door glass run seal. 16. Carefully position the glass aside, then remove the rear door glass top run. ALL VEHICLES 17. Disconnect the exterior door handle actuating rod from the rear door latch. 18. Remove the 3 rear door latch bolts. 19. Remove the rear door latch assembly. 20. Remove the remote cable cover from the latch. 21. Disconnect the interior door handle actuating cable from the rear door latch. 22. Remove the rear door latch from the bracket. * If necessary, remove the door lock actuator and the door ajar switch. INSTALLATION ALL VEHICLES Note: If necessary, install the door ajar switch and the door lock actuator. 1. Install the rear door latch on the bracket. 2. Connect the interior door handle actuating cable to the rear door latch. 3. Install the remote cable cover on the latch. 4. Position the rear door latch assembly. 5. Install the 3 rear door latch bolts. * Tighten to 12Nm (9 lb-ft). 6. CAUTION: The exterior door handle and the door latch must be installed and tightened to specification before connecting the exterior door handle actuating rod with the yellow clip. CAUTION: The exterior door handle actuating rod must be hanging freely then clipped into the door latch. Loading the exterior door handle actuating rod up or down when connecting may result in a misadjustment of the latch causing the latch not to operate correctly. Connect the exterior door handle actuating rod to the rear door latch and close the yellow clip. FIVE HUNDRED AND MONTEGO 7. Install the rear door glass top run and carefully position the glass. 8. Install the rear door glass run seal. 9. Install the rear door glass run top bolt. 10. Install the scrivet. 11. Raise the window glass and tape it in the full up position. ALL VEHICLES 12. NOTE: Make sure that the interior door handle does not get scratched when it is passed through the rear door module. Position the rear door module and install the 8 bolts. * Tighten to 8 Nm (71 lb-in). 13. Install the 3 rear door latch assembly-to-rear door module bolts. * Tighten to 12 Nm (9lb-ft). 14. Install push button rod on the rear door latch assembly. 15. Connect the rear door latch assembly electrical connector. 16. Position the interior door handle and loosely install the bolt. 17. Untape the window glass, then lower the window glass. 18. Install the window glass clamp bolt, * Position the window in the window clamp. * Shift the door window glass fully forward. * Tighten to 8 Nm (71 lb-in). 19. Install the access hole watershield. 20. Install the rear door trim panel. 21. Center the inside door handle alignment pins to the rear door trim panel and install the interior door handle bolt. * Tighten to 7 Nm (62 lb-in). EXTERIOR REAR DOOR HANDLE REMOVAL: Remove: 1. Remove the rear door latch. 2. CAUTION: Hold the bezel cap when removing the bolt or damage to the door may occur. Using a T-5 torx socket installed on the bolt tip, loosen the bezel cap bolt until the bezel cap can be removed. 3. Shift the exterior door handle rearward and remove the exterior door handle. 4. Remove the exterior door handle gasket. 5. Loosen the exterior door handle reinforcement bolt. 6. Remove the exterior door handle reinforcement from inside the door. 7. Release the bezel cap from the bezel and remove the bezel cap bolt. INSTALLATION 1. Install the exterior door handle reinforcement on inside the door. 2. Tighten the exterior door handle reinforcement bolt. * Tighten to 7 Nm (62 lb-in). 3. Install the exterior door handle gasket. 4. Install the exterior door handle. 5. Install the bezel and the bezel cap bolt. * Tighten to 12 Nm (9 lb-ft). 6. Position the exterior door handle forward. 7. Snap the bezel cap on to the bezel. 8. Install the rear door latch.
Is there a secret latch on 1997 Honda Passport to open the rear door?
The 1997 Honda Passport does not have a secret latch to open the rear door. The rear door latch can be found just above the license plate holder.
How do you repair rear door latch on a ford e350 van?
How to repair the rear door latches on my e 350 van. The bottom latch will not hold . How do I get the latch to hold Thanks
What is the rear leg room of the 2012 Chevrolet Suburban?
The 2012 Chevrolet Suburban has 39.5 in. of rear leg room.
What is the rear hip room of the 2007 Chevrolet Suburban?
The 2007 Chevrolet Suburban has 61.8 in. of rear hip room.
