answersLogoWhite

0


Best Answer

On a 1998 Ford Crown Victoria :

Overdrive is the normally allowed position , although the transmission will not

shift into overdrive until the speed is higher

If the overdrive is switched off , on the gauge cluster just to the right / and

above the speedometer you will see the O/D OFF warning light ( if you have the

digital dash it will show overdrive off in the upper right )

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you know when overdrive is on a 98 crown vic?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What side of the car is the starter located on 98 crown vic?

Passenger side.


What kind of oil use in 98 crown vic?

most use 5w30


Where is the dome light door switch located on a 1999 p71 Crown Victoria?

on my 98 crown vic you have to push in the head light switch


How do you reset check engine light on 98 crown vic?

Don't. It came on for a reason. Go to a garage.


Where is oil filter on 98 crown vic?

Drivers side of the car, in front, just under the exhaust manifold.


Why does your 98 crown vic jerks?

Change your cables they might be old and arcking...while your at it change your spark plugs


How do you take out coil-on-plug on a 98 ford crown vic?

Just remove the small screw. Comes right off.


Why would a 98 Crown Vic be stuck in park?

Check fuses, and check the shifter lock switch on the brake pedal.


Will a Ford crown vic 1998 fan belt fit a 2002?

sorry , no I checked www . motorcraft . com ( no spaces ) The 1998 Crown Vic takes Motorcraft Belt JK6 - 982D ( 98 + 2/8 inch circumference ) The 2002 Crown Vic takes Motorcraft Belt JK6 - 922A ( 92 + 2/8 inch circumference ) Helpfull


How do you replace ignition coil on 98 ford crown vic?

you have to replace your spark plug wires there is a coil on each wire for each cylinder.


1997 ford f 150 4.6L blow back thur gas cap?

This is interesting I have a 97 Crown vic . The gas tank sprung a leak and I replaced it with one from a 98 Crown vic . but the gas filler pipe is smaller . Now i have this very sensitive blow back problem . Is thias common with the 98 ? please answer to paulttq@yahoo.com thank you paul


What size are the rims on a 1994 ford crown vic?

standard size should be 15 inch. You will start to find 16 inch on '98 's