0
How do you open the hood of a Chevy Venture that has a broken release cable?
Wiki User
∙ 9y ago
Just finished opening a 97 Venture with hood release cable not attached. You need a flat 13mm ratchet, not offset not long, the gear wrench i used was 7".You have 4 bolts, some are easy some are not, come at the bolt from different angles. Once you get 3(I did lf-lr then rf rr) gently pry up the hood with a flat bar and your there. About 1 hour
Wiki User
∙ 9y ago
Anonymous
red head
Add your answer:
Earn +20 pts
Where is the speedometer cable on a Chevy Venture?
there is no speed cable, it has a electronic transmission with wires
How do you release broken parking brake cable on a 2000 Chevy Tahoe?
If its broken, then the cable is released. IF the breaks are still sticking, then the rear brakes will have to be opened up and the mechanism freed up.
How can you open the hood of a 1994 Chevy ilumina van when the cable release is broken?
omg u Have to go thru the grill and pull the release latch
How do you release the emergency brake if the cable is broke on a 1992 Chevy s10 it is the one you push with your foot?
It depends which cable is broken. If the main cable is broken under the truck, the brakes should release on their own. If the brakes dont release, the cables are frozen from rust and need to be replaced. If the release cable from the handle to pedal assemdly is broken reach under the dash above the pedal and find the small release arm. Pull the arm toward you [ the rear of vehicle ] and the emergency brake pedal will release.
How do you fix shifter cable on 1985 Chevy Celebrity?
If the cable is broken you should replace it.
You own a 88 Chevy beretta the hood release cable is broken how can you open the hood?
my Beretta is a 94 and it hood release is broke just the silver cable show ,,, i use needle nose pliers and pull it !
How do you open the hood on a 79 Chevy pickup when the cable is broken?
lmao a 79 chevy shouldnt have a cable.... its just a hand latch in the grill..
How do you replace a 2005 Chevy Trailblazer shift cable?
Buy the Cable , then remove the screws that hold the broken cable and attach the new cable back.
Can you release the parking brake on a 2001 Chevy silverado 1500 hd if the cable has broken?
on the side of the brake assembly is a lever with a "u" at the bottom pull or pry it rearward-this will release the pedal (BE CAREFUL IT WILL RELEASE HARD)
Can you release the parking brake if the cable brakes ON A 2004 AVALANCHE 1500 CHEVY?
parking brake is held on by a ratchet inside the car, ,so if the cable is broken your brakes will not be locked onif they are, you have more than a broken cable problem.--------------I beg to differ. It may be that it's only the release cable that is broken. This was the case in my older (79) Chevy Malibu. It wasn't the actual brake cable that broke. So my parking brake was stuck on. Ok then i did find a little lever part that i could pull back on beneath the dash, it was sort of connected to the parking brake pedal base. Look underneath the dash by the ebrake pedal, see if you can trace the route from the release handle to where its little pull cable might attach. That is the point where you would want to pull back to release the pedal. it worked for me, but of course it's a different type of Chevy. Just be careful as those moving parts will then release and you want to keep your fingers safe.--purry1
How do you open a hood release on a 1994 Chrysler caprice classic when the cable is broken?
There is no such thing as a Chrysler Caprice Classic. Chevy made a car called the Caprice (I had a 1969).
How do you fix the cable for the hatch release on a 92 Blazer S10?
It depends on where its broke at. Is the cable broken at the mechanical part or is it broken before that?
