That's a pretty cool operation, turn key to accessory, insert the end of a paper clip into the hole in the front of the switch , push key inward, turn key counter clock wise and pull the cylinder out, then you can remove the bezel.
There is a button on the back side of the switch that you push and hold while you pull the light knob out Forward. After this you can unscrew the hand nut either on the front or back of the switch that allows removal of the switch.
buy a Chevy
In order to remove the headlight switch of a 1988 Cadillac Eldorado, you must first disconnect the negative cable from the battery and allow time for the capacitors to discharge. Unscrew the headlight switch, remove the wire plugs, and remove the switch itself. Insert a new switch and replace the wire plugs and screws. Reconnect the negative cable and test the new switch.
Remove the knobs, remove the dash panel, and replace the switch.
To remove a ignition switch from a 1963 mercury meteor you must turn it off then unscrew it.
there is a pin on the switch which must be depressed to remove the unit from the dash.
On the back of the headlight switch
Disconnect the negative cable. Remove any screw from the switch. Slide the switch from the dash. Remove the switch and insert the new switch.
Remove the 4or5 screws along the top of the trim plate, the trim plate should pull off,the headlight switch is attached to the trimplate.
puch the knob on the headlight switch in, then turn it clockwise about a quarter inch, then pull it out. Its actually very easy.
it's your headlight switch
It is in the fuse box which is bolted to the headlight switch. You need to remove the headlight switch ti access it.