remove the plastic trim covering the 4 mount points, 2 front / 2 rear
the plastic trim is clipped on, so requires motivation to remove
(be careful for the front middle, as mine snapped away from the clip & i had to use epoxy to glue it back together)
remove the 4 T50 torx bolts
remove the 3 wiring connectors at the base
use the knob on the side to move the seatback forward as far as possible
lift the seat out :)
Underneath, inside left frame rail, aprox under the drivers seat.
Falcon Beach ended on 2007-03-30.
For Vito 96-03 the battery is removed sideways: - Remove a plastic cover on the left side of the seat. On LHD cars this is where the First-aid kit is situated - Remove the fuse holder by pressing the centre of the black plastic fasteners - Remove the plastic battery cover under the drivers seat - Remove one Torx screw in the left seat guide, otherwise this will hinder the battery from sliding out. - Remove the battery poles and the battery brackets on the bottom of the battery - Pull the battery out and push in the new one!
on my 03 carava there is a little button on the bottom where it slides into the seat
I have an 03 soft tail ... the fuse box is just rear of the battery ..... the battery and fuse box are under the seat .... you'll need to remove the seat to get to it ....
Drivers Republic was created in 2008-03.
i know on a two door, the back seat has a plastic clip in the shape of a "C" that acts like a spacer to prevent the seat from moving just a tiny bit "1inch" to either side, when the seat moves to one side the other can come free. to remove the seat you will have to remove the clip from the left hand side bottom hinge, lay the seat down and slide it over, the reason for laying the seat down is the hinge has a slot in it much like a key and lock, it will only come out once its lined up. its really easy once you've done it.
There are two of them, one under the drivers seat and the other under the hood, drivers side, down about 8 inches or so. It looks like a rectangular plastic black back with annoying plastic clips holding the lid on.
Use the seat belt and buckle up.
Here's what my Haynes manual says. I'm not sure if it pertains to a split seat or not. It may be more Cavalier oriented than Sunfire oriented. Unlatch the rear seat back and tilt it forward. Unhook the outer side belt retractor from the rear seat back. Remove the spacer from right key pin. Slide the seat back to the right and disengage the left key pin from the left key slot. Slide the seat back to the left and disengage the right key slot from the right from the right key slot. (Haynes gibberish?) Remove the seat back. Press the seat cushion retainer to the rear with a screwdriver. Lift the seat cushion up and remove it. Installation is the reverse of removal. Haynes has no photos of the procedure. FriPilot
it has 3
No.