0
How do you remove interior rear door panel from2002 Chrysler pt cruiser?
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Do you remove the timing belt on a Chrysler PT Cruiser when changing the head gasket?
Yes.Yes.
How do you remove the oil drain plug on a 2005 Chrysler PT Cruiser?
You turn it counter clockwise.
Is there a special tool used to remove the base of a 2007 Chrysler PT Cruiser antenna?
Yes.
What size socket to remove the upper intake manifold on a 2005 Chrysler PT Cruiser?
8 mm
How do you access the fuel pump on a Chrysler PT Cruiser?
You have to remove the fuel tank to access the pump.You have to remove the fuel tank to access the pump.
How do you remove the crankshaft pulley on a 2002 Chrysler PT Cruiser?
It requires a three jaw puller and a special tool that is inserted in place of the bolt.
How do you remove a rear door panel on a Chrysler PT Cruiser?
The rear door panel on a PT Cruiser can easily be removed by unscrewing the screws at the top and bottom. The exact location of the screws can be found in the user manual.
Where is the battery in a 2002 Chrysler PT Cruiser?
The battery is under the air intake box behind the left headlight. Its not that hard to remove the air box to get to the battery.
How do you replace the battery in a 2001 or newer Chrysler PT Cruiser?
Remove air filter box.take o ff hold down clamp.remove cable terminals and lift out..
How do you replace the crankshaft position sensor on a Chrysler PT Cruiser?
The crankshaft position sensor on the PT Cruiser is on the side of the engine above the oil filter. The sensor is removed with two screws. Unplug the wiring, remove the bolts, then install the new sensor.
Where is the transmission valve body in a 2002 Chrysler PT Cruiser?
If you remove the transmission pan, it is the part bolted to the inside of the transmission.If you remove the transmission pan, it is the part bolted to the inside of the transmission.
How do you remove the crankshaft pulley from a 2005 Chrysler PT Cruiser?
You use an impact wrench or breaker bar and spanner to remove the bolt.. a special insert is placed were the bolt was. Then a three jaw puller is used to pull the pulley off.
