Not an answerable question. Missing need option and specific identification of what steering shaft. There are at least three.
To remove the steering wheel from your 1985 Chevy Celebrity: First remove the horn button. There should be a keeper at the tip of the steering shaft, remove it. Remove the nut that holds the wheel in place. Use a steering wheel puller to actually remove the steering wheel.
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
remove ceter cap on steering wheel to gain access to large nut romve nut then use a steering wheel puller assembly pull steerinr wheel off the shaft
there is but it just puts lube in the intermediate shaft
Move the steering shaft. There is one bolt under the plastic cover. This is the pinch bolt .Remove it and slide shaft towards firewall ,move shaft out of the way ,replace plug,re-install shaft,bolt and plastic cover.
remove the air intake box for ez access to the steering shaft ,remove the plastic cover over the universal joint from the shaft to the steering box. Next remove the one bolt joining the two. use a pry bar to separate then push back the steering shaft. I used one of the longer used cables to tie the shaft in an up position ,no need to extract shaft fully. Go in through the flap of the wheel well to extract the old spark plug.
To remove the steering wheel in a 1988 Chevy Celebrity standard version: !. Remove the screws that hold the horn pad in place then remove it. Unplug the wire at the connector. 2, If it still has the safety clip remove it. 3, Use the appropriate wrench to remove the nut from the steering shaft. 4. Use a steering wheel puller to loosen then remove the steering wheel. Reverse the instructions to replace the steering wheel. Steering wheel retainer nut should be 30 ft. lbs. torque.
Remove the mower deck. Remove the phillips head screw at the end of the shaft underneath the mower. The releases your shaft from the bootom of mower. Remove steering wheel and remove shaft. Replace parts as needed.
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
It requires a SPECIAL tool that you can push the plate down with and then remove the lock ring that's around the steering shaft. There is a spring under the plate, IT MUST BE PUSHED DOWN TO REMOVE LOCK RING.
When removing steering box the steering wheel has to be removed steering shaft is not remove able it will have to slide down when steering box is removed ie then remove pit man arm and bolts from the frame
no, the intermediate steering shaft is completely independent of the power steering fluid operation. Make sure that when you remove the shaft, you DO NOT move the steering wheel. The clockspring inside the wheel is very easily damaged. no, I don't see why.