answersLogoWhite

0


Best Answer

You need to drop the fuel tank. Also you need to remove the hoses that go from the fill port to the tank.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the fuel pump on 1991 Toyota 4 runner?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel pressure regulator on the engine of a 1995 Toyota 4 Runner?

What should the fuel pressure be for a 1993 toyota 4 runner?


Where is the fuel pump located on a 1998 Toyota 4 runner?

in the fuel tank


How do you replace fuel pump on 1991 Toyota celica gt?

You will need to take the fuel tank off the 1991 Toyota Celica GT and remove the fuel pump and replace it. Always make sure to drain the gas before you take the tank off the car.


How do you reset check engine light on a Toyota 5 runner?

open fuse box remove efi [fuel injector fuse for about10 seconds


How do you replace the fuel pump located on a 1991 Toyota Corolla?

Should be ablo to remove the lower part of the backseat and there is an access hole to the tank where the fuel pump is.


What is the fuel capacity of a 1998 Toyota 4 Runner?

16 gallons


Where is the fuel pump located on a 1991 toyota camry?

It is in the fuel tank.


Where is the fuel pump located on a 2002 Toyota 4 runner?

Mounted inside and on top of the fuel tank.


Is there a fuel shut off button on a 1995 Toyota 4 runner?

no such thing


Have a 1991 Toyota 4 runner that will not start have put new fuel pump and new injectors and it still wont start?

Have you replaced the fuel filter? Are you sure the pump is running and the fuse is not blown or the relay is bad. Do you have fire, and do you have fuel pressure to the injectors?


What is the correct fuel pressure 1998 Toyota Tacoma?

what is the right pressure for a 1998 toyota tacoma pre runner


Where is the fuel filter located in a 1985 Toyota 4 runner?

Passanger side, above the starter. You have to remove the starter (don't detatch any wireing, just the 2 bolts). Once you have the starter out of the way, you can remove the fuel filter. Good luck, it's a PAIN!