Fuel Pumps
Toyota Corolla
Ford Explorer XLT

How do you replace the fuel pump located on a 1991 Toyota Corolla?

111213

Top Answer
User Avatar
Wiki User
Answered
2006-05-29 16:10:03
2006-05-29 16:10:03

Should be ablo to remove the lower part of the backseat and there is an access hole to the tank where the fuel pump is.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The 1991 Toyota Corolla cooling fan will stay on all the time if the temperature sensor is malfunctioning. Replace the temperature sensor.

In the corolla seca, it is the one in the fuse box located in the engine. There are two, located near the fan. (I just had to change mine)

The fuses in a 1991 Toyota Corolla are situated at two different spots, depending on the kind of fuse. Some are inside the car under the dash. There are other for engine components and these are located in a black box next to the wiper tubes.

31 gap according to my 1991 corolla manual.32 or 31

how do u remove cv axle driverside 1991 toyota corolla

The 1991 Toyota Corolla does not have a zero-clearance engine. It has a non-interference engine. This means that the pistons will not travel to the pistons.

go inside the trunk there should be a clip you push that down an pull the assimbly out an replace the burned out bulbs hope this helps you...

You should in the UK, as your car will fail the MOT test if your horn does not work.

drivers side kick panel, upper right fuse on the fuse block

The 1991 Toyota Corolla power window relay switch is located inside of the drivers side door. You will need to remove the drivers side door panel in order to access the relay switch.

On Engine, drivers side, under intake. Very tough to replace. Bad Toyota!

The starter on a 1991 Toyota Tercel is located in the front of the engine. It will be located on the left side.

Changing a rear license plate light on a 1991 Toyota Corolla will be very easy to do. You need to take the license plate off and then unscrew all the plastic screws holding the light cover in place. After the screws are out, remove the cover and unscrew the old bulb and replace it with a new one.

If by 'controller' you mean the switch that makes the brake lights come on, it is not in the trunk. It is located underneath the dashboard, next to the brake pedal.

location of the cold start switch on 1991 corolla auto

repair stripped motorcycle gear shift

There are a number of reasons why a 1991 Toyota Corolla engine would stop running after startup. It could the idle control, an EGR leak, or low fuel pressure.รŠ

I would like to see Corolla 2000 engine diagrammatically, possibly in different angels; break-downs.

An educated guess: 5 1/2 inch round - this is the case in my 1992 Corolla.

13 or 14 inch rims. Check on the tire for size.

Check the fuse on the kick panel 25amp fuse


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.