First, remove the lower dashboard panel in order to get at the switch. There are four Philips screws and one bolt that secures this panel. Then remove the two nuts and three bolts securing the steering column to the dash frame. This makes it easy to get at the switch. Remove the cover around the ignition switch. The front part is the key and lock tumbler, and the bottom is the electrical switch part that is not disturbed by this process. Take care not to pull the wires in the wire harness to the switch. Remove the key sensor switch from the housing that holds the tumbler and switch mechanism. Remove the screw that holds the ignition switch body. Remove the electrical harness part from the back of the switch. Then, insert the key and turn slightly. Release the pin under the tumbler casing and pull out the cylinder.
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
how to remove lock cyliner switch 1988 Isuzu pickup
how do you remove the ignition switch on a 1990 chevy half ton pick-up?
Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
remove the plastic surround. put the key in the ignition and turn to accessories . look at the end of the ignition switch cylinder for a small pin that will depress. when depressed the ignition will slide out. the new one goes in the same way . no tools needed except for the plastics part.
You have to remove it gently and go to auto zone and turn it in
how do you bypass electric window switch on 88 toyota pickup
How to remove ignition switch
http://au.answers.yahoo.com/question/index?qid=20080127140745AAsrO3M
The chrome ring on the outside unthreads from the inside piece.
Remove cowling from under the steering wheel, remove the two nuts holding the wheel coloum. Drop the steering coloum. Ignition switch is about a foot down on the left side. Unhook the wires remove switch replace. P.S. Unhook battery cables high voltage in ignition system.