1. Put the front of the car on jackstands and dis-connect the negative battery cable.
2. Remove passenger side wheel and lower splash guards. Using low profile 3/8" socket wrench or breaker bar, remove the serpentine belt from the alternator pulley.
3. Dis-connect the passenger side tie rod from the knuckle.
4. remove the driver side wheel.
5. Get 3 or 4 feet of extensions for your 3/8 socket wrench and feed them through the driver side wheel well to the upper bolt of the alternator. Yo may need to secure the socket & extensions on the bolt from up top then get back down to the driver wheel well, but it's worth the few seconds. Remove the upper bolt.
6. From below the car, loosen the lower bolt, but do not remove.
7. There is a small bracket on the alternator between mounting bolts. Remove the 10mm bolt that secures the bracket to the block.
8. From above, pry the upper tab from the mounting bracket.
9. Below the car, hold the alternator while removing the lower bolt.
10. Dis-connect the electrical to the Alternator.
11. Maneuver the alternator out through the passenger side wheel well. Takes a little thinking, but it'll come out.
12. Transfer the small bracket to the new alternator.
13. Feed the alternator in through the passenger side and make electrical connections.
14. Secure the lower alternator tab and hand tighten the lower bolt.
15. Pivot the alternator up. The upper tab may not easily fit into place. Tighten the 10mm bolt in the center bracket to the block. This will press the upper tab into place.
16. Install the upper bolt and hand tighten. Fully tighten the lower bolt now.
17. Use extensions from the driver wheel well to tighten the upper bolt.
Remainder of this project is simple re-assembly. An experienced shade tree mechanic can do this alternator R&R in under an hour after his tools are set out.
R134a
let the car run and then pull the negative battery cable off. if the car stalls, the alternator is bad! do you know where the bank 1 o2 sensor 2 is?
Where is the camshaft position sensor located on a 98 Mercury Mystique 2.4??
5'8
98' headlights look better
ON a '98 Mystique it's on engine between engine and radiator.It has a "T" shaped handle on top.
98 mystique has only one cat conveter
no
This information will be either on the door or the door jamb.
Rev limiter
AnswerAt the front of the engine will be a few components that have pulleys with a belts around them. Only one component will NOT have hoses going to it, but only wires. This is it.On my 98 mystique, it was located behind the motor on the passenger side. Just be careful when replacing it though, and probably change the alternator plug as well. My new alternator blew out the old plug. Had to have the car towed twice in 2 days!
wat are the head bolt spec on a 98 mercury mystique 2.0 4 cyl anyone knows were can i get this info thanks