The light bulb unit is found underneath the carpet behind each tail light area. Remove the plastic screws holding the trunk carpet to the interior sides behind the rear lights, follow the wiring to the center of the tail light, this is the light bulb unit-unscrew and remove.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace
Bulb is probably defective. Replace it.
open trunk - unpin the hard trunk liner below the light in the trunk (underneath where the package tray is located) twist the fixture approx. 1/4 turn remove from hole and pull out the bulb and replace it. -single element)
It is on a bracket just above the brake pedal.
No, it is a brake light.
Should be at the upper end of the brake pedal under dash area
On the bracket the brake pedal mounts to.
I just replaced a blown third brake light bulb today. ... I have about 60k on my M and havent yet had to change the brake light---so if it only has to be done once in the ... If memory serves, the Concorde's is in the rear window. ... Well I decided to mod my 2004 300Mspecial Third Brake lights, not with a bulb ...
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
How to replace a brake light on a nissan Tiida hatch back.