0
it's tricky to get to but as long as you have ramps or jack stands it will be easy. once the car is off the ground high enough that you can fit underneath the engine, slide under neath and look for the starter. the starter blocks your access. remove the starter and you will see the single wire connection and the single bolt. remove the wire using a screw driver to pry the clip and undo the bolt. after that, use a pair of adjustable goose neck pliers to grab and twist the sensor and it pops out. to install do everything in reverse. grab and twist the sensor giving a little pressure to push it in place. then align and bolt down and hook the wire back, reinstall the starter and make sure it is properly mounted and you are ready to go.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Do you need to replace cam sensor after replacing the crank sensor?
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
Do you have to replace anything else along with the camshaft sensor?
Usually pretty common to have the replace the crank sensor or crank angle sensor. Before you do replace the camshaft sensor check that your timing is right on because this is the issue with about 75% of vehicles.
How much is it to replace a crank sensor?
How much will it cost to replace a cank sensor on a Mazada 626?
How do you replace a crank position sensor on a 2001 Mitsubishi galant?
Where is the crank position sensor 0n a 2001 mitsubishi Galant
How do you replace a crank sensor on a 98 cavalier?
Bob
How do you replace a crank sensor on a 2004 jetta?
How_do_you_replace_a_crank_sensor_on_a_2004_jetta
How do you replace a crank angle sensor on mercury sable?
You need to remove the serpentine belt and alternator in order to get the crank sensor; one 10mm bolt holds it. It is easy to replace.
Why do you keep breaking motor mounts?
replace crank sensor
How do you replace a cam sensor on a 1990 lumina 3.1?
There is no cam sensor on a 90 3.1. Only a crank sensor.
Where is the crank position sensor located on a 1993 Infinity G20?
trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor
How do you replace a 95 Mitsubishi crank sensor?
how to ins toll a crank sensor on a 95 Mitsubishi 6v, but first of all my car crank to the point that it wanted to start but it does not start what might be the problem.
